Abstract:Managing heavy oil (HO) has become a vital issue in terms of environmental considerations. Microwave pyrolysis of HO is one of the efficient methods of upgrading and recycling this complex material. In this work, microwave catalytic pyrolysis (MCP) of HO was explored by investigating the effect of heating time (2–10 minutes) and temperature (460–730oC) on the product yield and quality. The most critical point of this study was utilizing a unique design of SiC foam@HZSM-5 as a microwave absorber and catalyst simultaneously. This special design could eliminate the main problem of previous studies: the unwanted temperature gradient inside the reactor, which was misleading the prediction of kinetic parameters by recording the wrong temperature. The yield of each product's category from the MCP process was reconstructed through a biharmonic spline interpolation (BSI) algorithm to visualize the simultaneous effect of the heating time and temperature on the yield. The optimum temperature for the MCP process was about 600oC and a heating time of 6 minutes, which yielded the most valuable hydrocarbons in liquid and gas products. The produced liquid oil and non-condensable gases were analyzed through GC-MS and the collected results were categorized based on the properties of the detected compounds. An eight-lump kinetic model was then proposed based on that categorization. The calculated pre-exponential factors ( k0 ) were higher than the expected values, while the apparent activation energies ( Ea ) were considerably lower than the reported data in the literature, which was due to the non-thermal and thermal effects of microwave irradiation on the reaction mechanism. The validation of the proposed model indicated the capability of this model to predict reliable data under these conditions.

A Study of the Pyrolysis of Heavy Oil in Supercritical Cyclohexane: Experiments and Molecular Dynamics Simulations

Dissolution Behavior of Polycyclic Aromatic Hydrocarbons in Heavy Oil in the Presence of Supercritical Cyclohexane

Pyrolysis of heavy oil in the presence of supercritical water: The reaction kinetics in different phases

A Six-Lumped Kinetic Model of Pyrolysis of Heavy Oil in Supercritical Methanol

Pyrolysis of Hexadecane as Model Compound in Supercritical Water

Lumped reaction kinetic models for pyrolysis of heavy oil in the presence of supercritical water

Co-pyrolysis of Heavy Oil and Low Density Polyethylene in the Presence of Supercritical Water: the Suppression of Coke Formation

Analysis of Pyrolysis Property of Cyclohexane under Supercritical Conditions

Experimental Investigation of Upgrading Heavy Oil with Supercritical Methanol

Dissolution of Polycyclic Aromatic Hydrocarbons in Subcritical and Supercritical Water: A Molecular Dynamics Simulation Study

High-Temperature and High-Pressure Pyrolysis of Hexadecane: Molecular Dynamic Simulation Based on Reactive Force Field (Reaxff)

Molecular Dynamics Simulation of Heavy Oil Dissolution in Supercritical Water and Multi-Component Thermal Fluid

Co-hydropyrolysis of Pine and HDPE over Bimetallic Catalysts: Efficient BTEX Production and Process Mechanism Analysis

A comparative single-pulse shock tube experiment and kinetic modeling study on pyrolysis of cyclohexane, methylcyclohexane and ethylcyclohexane

Initiated Pyrolysis of Heavy Oil in the Presence of Near-Critical Water

Demetalization of Heavy Oil Based on the Preferential Self-assembly of Heavy Aromatics in Supercritical Water

Kinetic Study of Asphaltenes Phase Separation in Supercritical Water Upgrading of Heavy Oil

Microwave catalytic pyrolysis of heavy oil: A lump kinetic study approach

A Molecular Dynamics Simulation Investigation on the Solubility of Polycyclic Aromatic Hydrocarbons in Supercritical Water

Experimental and Modelling Studies on Pyrolysis and Its Main Light Gas Products for Typical C8 Hydrocarbons

A molecular kinetic model for heavy gas oil catalytic pyrolysis to light olefins