Abstract:Metallic materials are widely employed due to their exceptional mechanical attributes. Plastic deformation common issue that influences both the mechanical and electrical properties, with profound implications for longevity of engineered structures and components. Dislocation density is the core factor in the plastic deformation process. Traditional methods for the evaluation of dislocation density include electron backscatter diffraction (EBSD), transmission electron microscopy (TEM), and x-ray diffraction (XRD), requiring meticulous specimen preparation and sophisticated equipment posing challenges for industry-wide fitness-for service (FFS) monitoring. To address these challenges, a non-contact method to quantitatively evaluate dislocation density in stainless steel 316L (SUS316L) by employing a microwave reflection method is reported in this study. A dedicated microwave measurement system, coupled with a coaxial line sensor, was used measure the amplitude of the reflection coefficient of the microwave signal at a constant standoff distance frequency, closely associated with the electrical resistivity of the SUS316L specimens, a parameter that exhibits variation in response to changes in dislocation density. The results indicate a proportional increase in amplitude of the microwave signal with higher dislocation density. By establishing a linear correlation, demonstrate the feasibility of evaluating dislocation density with a minimum detectable difference of 1.824 1013 13 m-2 using the dedicated microwave system under the designed conditions in this study. This approach holds promise for better understanding and monitoring of plastic deformation in metallic materials across various applications.

In-situ Density Measurement for Plastic Injection Molding Via Ultrasonic Technology

In-situ ultrasonic measurement of molten polymers during injection molding

High Precision Ultrasonic Testing Method for Density of Engineering Plastics

Non-destructive measurement of cavity pressure during injection molding process based on ultrasonic technology and Gaussian process

Visualization and Monitoring of the Injection Molding Process Using Ultrasonic Phased Array

Ultrasound Sensors for Process Monitoring in Injection Moulding

In situ monitoring of FDM machine condition via acoustic emission

Ultrasonic Measurement of Clamping Force for Injection Molding Machine

A Nondestructive Online Method for Monitoring the Injection Molding Process by Collecting and Analyzing Machine Running Data

On-line detection of plastic injection molding process by ultrasonic technology

Fast prediction of crystallinity in injection molding during the packing stage

In-situ ultrasonic characterization of microcellular injection molding

Quantitative Evaluation of Dislocation Density in SUS316L Utilizing Non-Contact Microwave Reflection Method

Nondestructive measurement for wall thickness of product molded by fluid-assisted co-injection molding using ultrasound

On-line measurement of cavity pressure during injection molding via ultrasonic investigation of tie bar

A Statistical Quality Monitoring Method for Plastic Injection Molding Using Machine Built-in Sensors

Non‐destructive Characterisation of Polymers During Injection Moulding with Ultrasonic Attenuation Measurement

Development of A Transducer for In-Line and Through Cycle Monitoring of Key Process and Quality Variables in Injection Molding

On-line in-mold transducer in injection molding

Measurement of Molecular Orientation Using Longitudinal Ultrasound and Its First Application in In-Situ Characterization

In situ flow state characterization of molten resin at the inner mold in injection molding