Abstract:Compressible flow past a circular cylinder at an inflow Reynolds number of 2 x 10 5 is numerically investigated by using a constrained large-eddy simulation (CLES) technique. Numerical simulation with adiabatic wall boundary condition and at a free-stream Mach number of 0.75 is conducted to validate and verify the performance of the present CLES method in predicting separated flows. Some typical and characteristic physical quantities, such as the drag coefficient, the root-mean-square lift fluctuations, the Strouhal number, the pressure and skin friction distributions around the cylinder, etc. are calculated and compared with previously reported experimental data, finer-grid large-eddy simulation (LES) data and those obtained in the present LES and detached-eddy simulation (DES) on coarse grids. It turns out that CLES is superior to DES in predicting such separated flow and that CLES can mimic the intricate shock wave dynamics quite well. Then, the effects of Mach number on the flow patterns and parameters such as the pressure, skin friction and drag coefficients, and the cylinder surface temperature are studied, with Mach number varying from 0.1 to 0.95. Non-monotonic behaviors of the pressure and skin friction distributions are observed with increasing Mach number and the minimum mean separation angle occurs at a subcritical Mach number of between 0.3 and 0.5. Additionally, the wall temperature effects on the thermodynamic and aerodynamic quantities are explored in a series of simulations using isothermal wall boundary conditions at three different wall temperatures. It is found that the flow separates earlier from the cylinder surface with a longer recirculation length in the wake and a higher pressure coefficient at the rear stagnation point for higher wall temperature. Moreover, the influences of different thermal wall boundary conditions on the flow field are gradually magnified from the front stagnation point to the rear stagnation point. Moreover, the influences of different thermal wall boundary conditions on the flow field are graduallymagnified from the front stagnation point to the rear stagnation point. It is inferred that the CLES approach in its current version is a useful and effective tool for simulating wall-bounded compressible turbulent flows with massive separations.

Non-isothermal Flow Past a Heated Circular Cylinder in Subcritical Regime: a Numerical Investigation Based on Large-Eddy Simulation

Constrained Large-Eddy Simulation of Compressible Flow Past a Circular Cylinder

New Insight on Large-Eddy Simulation of Flow Past a Circular Cylinder at Subcritical Reynolds Number 3900

Three-dimensional Numerical Simulation on Flow Past Three Circular Cylinders in an Equilateral-Triangular Arrangement

An Experimental Investigation of Flow Past a Smooth Circular Cylinder at the Sub-Critical Region

Numerical Simulation on Flow and Heat Transfer Characteristics of Film/Regenerative Compound Cooling Process

Study of the Flow Around a Cylinder from the Subcritical to Supercritical Regimes

Numerical Research of Flow Past a Circular Cylinder with Splitter Plate at a Subcritical Reynolds Number Region

The characteristics of flows past a circular cylinder with heat transfer in the proximity to the wall at different gap ratios

Numerical Calculations for Smooth Circular Cylinder Flow at 3900 Reynolds Numbers with SST-IDDES Turbulence Model

Numerical Studies of Wake Characteristics on a Circular Cylinder at Sub-critical Reynolds Number

Numerical Simulation of Flow and Heat Transfer in Rotating Square Duct with Varied Density Ratio

Numerical study on flow and heat transfer characteristics of low pressure gas in slip flow regime

Large eddy simulations of flow around a 3D cylinder at subcritical reynolds number

Numerical Simulations of Steady Flow over a Circular Cylinder Near a Boundary

Numerical Study of Flow Characteristics Around Square Cylinder at High Reynolds Number

Numerical Simulation of Thermal-Dynamic Characteristics through a Helical Coiled Tube with Annular Cross Section for Laminar Flow

Analysis of Flow and Thermal Characteristics in a Rectangular Chamber with a Hollow Cylinder under a Horizontal Turbulent Buoyant Jet

A numerical study of steady viscous flow past a circular cylinder

Numerical investigation of laminar natural convective heat transfer from a horizontal triangular cylinder to its concentric cylindrical enclosure

Numerical Study on Compressible Flow Arounda Circular Cylinder in Proximity to the Wall