Abstract:574 Objectives: Promising results have been reported for low-statistics PET data denoising using a deep convolutional neural network (CNN) with standard-statistics images as the target and low-statistics images as input for training. The trained network can generate denoised low-statistics images, which have similar noise level as the standard-statistics images. The long axial field-of-view (AFOV) scanner of the PennPET Explorer leads to very high sensitivity and permits low dose, fast, and/or late imaging. A CNN trained on the high-count data from the PennPET scanner will be able to generate virtual-high-statistics images to permit ultra-low dose, ultra-fast, and/or ultra-late imaging. In this study, we investigated and optimized a fully 3D U-Net architecture for the PennPET Explorer data denoising. Methods: Two subjects were injected with 15 mCi FDG and scanned in a single bed position on the time-of-flight (TOF) PennPET Explorer scanner (currently with 64-cm AFOV). Subject #1 was scanned for 20 min after 105 min post-injection. Subject #2 was scanned for 20 min after 85 min post-injection, and then an ultra-late scan was acquired for 60 min after 10 half-lives of FDG (~18 hr post-injection). For each subject, 10 low-count (5% of full count, 1-min data) samples were generated by independent sampling from the full-count (20-min) data. All the images were reconstructed by list-mode TOF OSEM (25 subsets, 4 iterations). The image size was 288×288×320 with voxel size of 2×2×2 mm3, and then cropped to 144×272×320 for denoising. A fully 3D U-Net was trained for denoising by minimizing the L2 loss function using Adam optimization. The 10 low-count and 1 full-count images from subject #1 were used as input and target for training, respectively, and the 10 low-count images from subject #2 were used for testing. To augment the training dataset, a patch-based method was used with 64×64×16 patch size. To reduce artifacts on the tile edge caused by the overlapping-tile strategy, 144×272×160 patch size was used in testing. Regions of interest (ROIs) of cerebellum, bone marrow, myocardium, aorta wall, and lung were drawn on the full-count image of subject #2. The quantification accuracy was evaluated using the relative bias of ROI mean value with the full-count image as ground truth. The background noise was evaluated using the normalized standard deviation in the lung ROI. Finally, the trained network was applied to the ultra-late scan of subject #2 to generate a low-noise virtual-high-statistics image. Results: The trained 3D U-Net can generate denoised low-count images, which have comparable image quality as the full-count image. The aorta wall can be clearly identified in the denoised images, but not in the original low-count images. The quantification results showed that the noise levels in the low-count images were greatly reduced by a factor of about 4.5 after denoising, which were similar to that in the full-count image. The relative bias values in all ROIs were below 6% in the denoised low-count images. Finally, a low-noise virtual-high-statistics ultra-late image was generated using this optimized 3D U-Net, though further network training might be needed using images with matched noise levels in ultra-late scans. Conclusions: Fully 3D U-Net is able to predict full-count images from low-count data acquired on the PennPET Explorer scanner, although additional human data are needed to further optimize the network. The high sensitivity of long AFOV scanners coupled with an optimized CNN, may permit ultra-low dose, ultra-fast and/or ultra-late imaging. The optimized 3D U-Net can be further used for generating high quality images for ultra-late scans, which may enable significant clinical and research applications.

Deep Learning-Based Denoising in Brain Tumor CHO PET: Comparison with Traditional Approaches

PET Image Denoising Using Unsupervised Deep Learning.

Population and Individual Information Guided PET Image Denoising Using Deep Neural Network

Investigation of Lesion Detectability Using Deep Learning Based Denoising Methods in Oncology PET: a Cross-Center Phantom Study

An Investigation of Quantitative Accuracy for Deep Learning Based Denoising in Oncological PET.

Convolutional neural networks for improving image quality with noisy PET data

A Personalized Deep Learning Denoising Strategy for Low-Count PET Images

CT-guided PET Image Denoising Using Deep Neural Network Without Prior Training Data

Deep Learning-Based Denoising for PennPET Explorer Data

A Noise-level-aware Framework for PET Image Denoising

Full-Dose PET Image Estimation from Low-Dose PET Image Using Deep Learning: a Pilot Study

The Impact of Noise Level Mismatch Between Training and Testing Images for Deep Learning-Based PET Denoising

PET Denoising and Uncertainty Estimation Based on NVAE Model Using Quantile Regression Loss

Unsupervised PET logan parametric image estimation using conditional deep image prior.

Noise Reduction For Short Time Pet Imaging With Conventional And Deep Learning Based Methods

Adaptive Whole-Body PET Image Denoising Using 3D Diffusion Models with ControlNet

Rethinking PET Image Reconstruction: Ultra-Low-Dose, Sinogram and Deep Learning

An efficient method for PET image denoising by combining multi-scale transform and non-local means

Populational and individual information based PET image denoising using conditional unsupervised learning

Denoising approaches by SubtlePETTM artificial intelligence in positron emission tomography (PET) for clinical routine application

Anatomical-guided attention enhances unsupervised PET image denoising performance