Abstract:Rail grinders belonging to special vehicles have fewer accidents than general railroad vehicles and parts, and the causes are diverse. Therefore, there is a lack of basic data for inspection methods and preventative measures necessary for accident prevention, and the collection and analysis of accident cases are also necessary. In this paper, a failure analysis of the recently derailed rail grinding car's rotating shaft was conducted. Various analyses, including fractography, chemical analysis, metallography and hardness measurement, were performed on the failed shaft. In the fracture surface of the shaft, ratchet marks and fatigue striations indicative of fatigue failure were observed. Consequently, it was confirmed that the failure of the shaft was attributed to fatigue, with the primary cause being identified as the cracks found on the fillet area surface. Chemical analysis of the observed inclusions in the sample revealed manganese (Mn) at 6.16 wt% and sulfur (S) at 1.35 wt%. These are attributed to non-metallic MnS inclusions, which are presumed to have adversely affected the fatigue strength of the material. Additionally, hardness deficiency due to heat treatment defects on the shaft surface was identified. The surface hardness measured approximately HV400, suggesting that it is desirable to achieve a surface hardness of HV600 or HRC55 or higher during high-frequency heat treatment. Lastly, the finish state of the fillet area surface was not smooth. Given that the fillet area is a region where stress concentration occurs, the presence of such machining traces raises the possibility of progressing into fatigue cracks. Finite element analysis revealed that the von-Mises stress was less than the yield strength of the material, and a safety factor based on the yield strength was calculated to be 3.5. The results confirmed that fatigue cracks in the fillet area were caused by the hardness deficiency due to the poor heat treatment, the rough surface finish, and the presence of non-metallic inclusions.

Cause Analysis and Countermeasure on Premature Failure of a Driven Gear for the High-Speed Train

Failure Analysis of Worm Gear in Worm Transmission

Analysis of Bearing Failures in a Typical High-Power Marine Gearbox

Failure Analysis of a Gearbox of a Conveyor Belt

Failure analysis of the rotating shaft in the rail grinding car

Gearbox Lubrication Failure Modes and Discrimination of Locomotives for High-speed Railway

Analysis of the dynamic contact behaviour of high-speed train transmission gear excited by wheel defects

Failure analysis on abnormal cracking of polycarbonate plates used in the gearbox oil level gauge for high-speed train

Failure Analysis on Abnormal Wear of Roller Bearings in Gearbox for Wind Turbine

Multi-Condition Contact Stress Analysis of High Speed Train Helical Gear

Tooth surface analysis method based on thermo-mechanical coupling and its application in prediction of gear dry-running bearing capacity

Fracture failure analysis of the teeth of conjunction gear made of 20MnCr5S steel

Partial Load: A Key Factor Resulting in the Failure of Gear in the Wind Turbine Gearbox

Study on the Influence of Gear Rattling on Pitting Fatigue Failure

Fracture failure analysis of transmission gear shaft in a bidirectional gear pump

Failure Analysis on Abnormal Cracking of the Baffle in the Automatic Passing Neutral Section Sensor for High-Speed Trains

Finite Element Simulation and Fatigue Damage Analysis of High-Speed Train Gearbox Shell Based on Structure and Material Cross-Scale Correlation

Torsional vibration analysis of the gear transmission system of high-speed trains with wheel defects

A fatigue failure investigation and improvement of a high-speed cylindrical roller bearing in a turbofan engine

Dynamic response analysis of high-speed train gearboxes excited by wheel out-of-round: experiment and simulation

Effect of Gear Tooth Cracks on the Dynamic Characteristics of Gear Transmission System of High-Speed Train