Optimization of residual stress in low-pressure casting of ZL205A alloys
Zonghao Zhang,Jianhui Liu,Jinming Chen,Fulin Wen,Ru Jia,Qingxian Ma
DOI: https://doi.org/10.1016/j.jmapro.2023.05.040
IF: 5.684
2023-01-01
Journal of Manufacturing Processes
Abstract:ZL205A alloys are prone to generate serious residual stress due to the long solidification intervals and multiphase composition. In this study, the low-pressure casting process for ZL205A alloy hemisphere shell casting was investigated and continuously optimized. In the initial process, the knockout time, pouring temperature, preheating temperature of the sand mould, dwelling pressure, and filling rate were 3 h, 710 degrees C, 30 degrees C, 65 kPa, and 0.33 kPa center dot s(-1), respectively. Macroscopic properties and microstructural features were simulated using a combination of ProCAST and Thermal-Calc software. Additionally, a series of experimental procedures, including EBSD, SEM, EDS, and XRD tests, were conducted to investigate the formation, morphology, and distribution of the microstructure. Current findings demonstrate that during the solidification process, the maximum temperature difference exceeds 220 degrees C, the maximum undercooling reaches 49.56. degrees C, and the maximum effective stress peaks at 301.7 MPa. The residual stress ranges from 20 to 200 MPa. Furthermore, there is no significant texture and preferred grain orientation during nucleation and solidification, and the structure field exhibits an equiaxed crystal but inhomogeneous pattern. Moreover, the finer and more homogeneous the grains and the smaller the deviation in grain orientation, the lower the residual stress. Specifically, two analytical models are developed: one between the casting parameters and the residual stress, and another between the shrinkage defects and the casting parameters. The lowest residual stress is achieved when the knockout time, pouring temperature, pre-heating temperature of the sand mould, dwelling pressure, and filling rate are 6 h, 725 degrees C, 250 degrees C, 95 kPa, and 1.67 kPa center dot s(-1) respectively.