Abstract:In this paper, a highly sensitive paper-based humidity sensor is designed and fabricated to overcome the typically low sensitivity and small quality factor of paper-based chipless radio-frequency identification (RFID) humidity sensors. A toroidal inductor-interdigitated electrodes (IDE) capacitor is used as the resonator structure of the new sensor, and the structural parameters of the sensor are optimized using the software of high frequency structure simulator (HFSS) to improve the quality factor. Three paper-based sensor samples were fabricated via screen printing using regular printing paper, Kodak photo paper, and double-sided copper-coated paper as the substrate. In addition, the resonance characteristics, sensitivity, recovery characteristics, stability and other sensor performances were tested. The results show that the sensitivity of the copper-coated-paper-based sensor is significantly better than the two other paper-based sensors. The simulation and test results of the moisture-sensitive characteristics are consistent for graphene oxide (GO) films, which were prepared using the spray method on the surface of the copper-coated-paper-based sensor with mass concentrations of 1 mg/mL, 2 mg/mL, and 5 mg/mL. This indicates that GO films can significantly improve sensor sensitivity when combined with paper-based moisture sensing. Furthermore, the sensitivity increases with increasing GO concentration, the 5 mg/mL GO sensor show a sensitivity of 6.25 MHz/%RH and a range of 60% RH-90% RH. The 1 mg/mL GO humidity sensor shows good recovery characteristics (92.4% recovery). Based on the presence of hydrophilic functional groups in the GO material, a moisture sensing mechanism that GO could improve the sensitivity of the sensor is analyzed.

High-Performance PCF-SPR Sensor Coated with Ag and Graphene for Humidity Sensing

Analysis of Graphene-Based Photonic Crystal Fiber Sensor Using Birefringence and Surface Plasmon Resonance

Fiber Optic Relative Humidity Sensor Based On The Tilted Fiber Bragg Grating Coated With Graphene Oxide

Humidity sensor based on core-offset fiber Mach-Zehnder interferometer coated graphene oxide film

Flexible Humidity Sensors with High Water-Resistance Based on a Composite of Sodium Carboxymethyl Cellulose, Graphene Oxide and 3-Glycidyloxypropyl Trimethoxysilane

Highly Sensitive Humidity Sensor Based on a GO/Co-MOF-74 Coated Long Period Fiber Grating

High performance graphene oxide-based humidity sensor integrated on a photonic crystal cavity

Graphene-Coated Highly Sensitive Photonic Crystal Fiber Surface Plasmon Resonance Sensor for Aqueous Solution: Design and Numerical Analysis

High-sensitivity Humidity Sensing of Microfiber Coated with Three-Dimensional Graphene Network

A D-Shaped Photonic Crystal Fiber Refractive Index Sensor Coated with Graphene and Zinc Oxide

Light Humidity Sensor of Surface Plasmon Resonance by Symmetric Metal Film

Ultra-sensitive and Responsive Capacitive Humidity Sensor Based on Graphene Oxide.

Polyelectrolyte/Graphene Oxide Nano-Film Integrated Fiber-Optic Sensors for High-Sensitive and Rapid-Response Humidity Measurement

High Sensitivity Humidity Detection Based on Functional GO/MWCNTs Hybrid Nano-Materials Coated Titled Fiber Bragg Grating

A highly sensitive paper-based chipless RFID humidity sensor based on graphene oxide

Humidity Sensor Composed of Laser-Induced Graphene Electrode and Graphene Oxide for Monitoring Respiration and Skin Moisture

A HUMIDITY SENSOR WITH HIGH SENSITIVITY AND LOW TEMPERATURE COEFFICIENT OF FREQUENCY BASED ON ALN SURFACE ACOUSTIC WAVE AND GRAPHENE OXIDE SENSING LAYER

A High Performance Humidity Sensor Based on Surface Acoustic Wave and Graphene Oxide on AlN/Si Layered Structure

A humidity sensor based on quartz crystal microbalance using graphene oxide as a sensitive layer

Ultrafast Freestanding Microfiber Humidity Sensor Based on Three-Dimensional Graphene Network Cladding.