Co-assembly of graphene/polyoxometalate films for highly electrocatalytic and sensing hydroperoxide

Yayan Bao,Zezhong Chen,Yuzhen Wang,Lizhen Liu,Haiyan Wang,Zuopeng Li,Feng Feng
DOI: https://doi.org/10.3389/fchem.2023.1199135
IF: 5.5
2023-05-18
Frontiers in Chemistry
Abstract:Graphene oxide (GO) films mixed with polyethylenimine (PEI) were prepared by a layer-by-layer assembly (LBL) method, in which the GO component is then converted to reduced GO (rGO) in situ through an electron transfer interaction with a polyoxometalate (POM) that is assembled on the outer surface. With this, devices were manufactured by spreading composite films of (PEI/rGO) n -POM with different numbers of PEI/rGO layers on ITO substrates. Cyclic voltammetry (CV) reveals that the catalytic activity for H 2 O 2 of (PEI/rGO) n -POM films was significantly higher than that of similar films of (PEI/GO) n /PEI/POM manufactured LBL with the same number of layers, although the catalyst POM content of (PEI/rGO) n -POM was only half that of (PEI/GO) n /PEI/POM. The catalytic activity of (PEI/rGO) n -POM films first increases and then decreases as the number of PEI/rGO layers increases. The result shows that (PEI/rGO) 3 -POM films with three PEI/rGO layers exhibit the highest efficiency. Amperometric measurements of the (PEI/rGO) 3 -POM films showed improved current response, high sensitivity, wide linear range, low detection limit, and fast response for H 2 O 2 detection. The enhanced catalytic property of (PEI/rGO) n -POM films is attributed to the electron transfer interaction and electrostatic interaction between POM and rGO.
chemistry, multidisciplinary
What problem does this paper attempt to address?