Abstract:The Nyquist wavelength-division multiplexing technique enable a solution to achieve high spectral efficiency in long-haul transmission system. Compare to polarization division multiplexing quadrature-phase-shift-keying, even high-level modulation scheme such as polarization division multiplexing 16-quadrature-amplitude-modulation is much more sensitive to intra-channel noise and inter-channel linear crosstalk caused by Nyquist wavelength-division multiplexing. We experimentally demonstrated the generation and transmission of the 6 × 128-Gb/s Nyquist wavelength-division multiplexing sixteen quadrature amplitude modulation signal over 1200-km single-mode fiber (SMF)-28 with Erbium-doped fiber amplifier only amplification with a net SE of 7.47 b/s/Hz, which is so far, to our knowledge, the highest SE for the signal with the bit rate above 100-Gb/s using the polarization-division multiplexing 16-quadrature-amplitude-modulation format. This experiment was successfully enabled by digital-signal-processing (DSP) pre-equalization of transmitter-side impairments and DSP post-equalization of the channel and receiver-side impairments. Nyquist-band is considered in the pre- equalization to enhance the tolerance of the polarization-division multiplexing 16-quadrature-amplitude-modulation to the aggressive spectral shaping. The bit error rate for each of the 6 channels is smaller than the limitation of the forward-error-correction limit of 3.8 ×10-3 after 1200-km SMF-28 transmission.

Field Trial Nyquist-WDM Transmission of 8#x000d7;216.4gb/s PDM-CSRZ-QPSK Exceeding 4b/s/hz Spectral Efficiency

Field Trial Nyquist-WDM Transmission of 8×216.4gb/s PDM-CSRZ-QPSK Exceeding 4b/s/hz Spectral Efficiency

Transmission of 200 G PDM-CSRZ-QPSK and PDM-16 QAM With a SE of 4 b/s/Hz

Field Trial for the Mixed Bit Rate at 100G and Beyond

Field Transmission of 100 G and Beyond: Multiple Baud Rates and Mixed Line Rates Using Nyquist-WDM Technology

7 $\,\times\,$ 224 Gb/s/ch Nyquist-WDM Transmission over 1600-Km SMF-28 Using PDM-CSRZ-QPSK Modulation

Field Transmission of I OOG and Beyond: Multiple Baud Rates and Mixed Line Rates Using Nyquist-WDM Technology

WDM Transmission of 108.4-Gbaud PDM-QPSK Signals (40×433.6-Gb/s) over 2800-Km SMF-28 with EDFA Only

Transmission Of 8x128.8gbaud Single-Carrier Pdm-Qpsk Signal Over 2800-Km Edfa-Only Smf-28 Link

Transmission of 8×128.8Gbaud single-carrier PDM-QPSK signal over 2800-km EDFA-only SMF-28 link

10&Amp;#x00d7;440-Gb/s Super-Nyquist-filtered Signal Transmission over 3000-Km Fiber and 10 Cascaded ROADMs with 100-Ghz Grid Based on Single-Carrier ETDM 110-Gbaud QPSK

Transmission of 20×440-Gb/s super-nyquist-filtered signals over 3600 km based on single-carrier 110-GBaud PDM QPSK with 100-GHz grid

32Tb/s (320×114Gb/s) PDM-RZ-8QAM transmission over 580km of SMF-28 ultra-low-loss fiber

Real-time 10-.x800-Gb/s Sub-carrier-multiplexing 95-GBd DP-64QAM-PCS Transmission over 2018-km G.654.E Fibre with Pure Backward Distributed Raman Amplification

6$\,\Times\,$ 128-Gb/s Nyquist-WDM PDM-16QAM Generation and Transmission over 1200-Km SMF-28 with SE of 7.47 B/s/hz

6 128-Gb/s Nyquist-WDM PDM-16QAM Generation and Transmission Over 1200-km SMF-28 With SE of 7.47 b/s/Hz

Transmission of single-carrier 400G signals (515.2-Gb/s) based on 128.8-GBaud PDM QPSK over 10,130- and 6,078 km terrestrial fiber links.

82.29-Tb/s (182x560-Gb/s) Transmission of 42GHz-Spaced WDM PDM-128-QAM OFDM Signals over 100-km SMF

400 G Transmission of Super-Nyquist-Filtered Signal Based on Single-Carrier 110-Gbaud PDM QPSK with 100-Ghz Grid

64-Tb/s (640×107-Gb/s) PDM-36QAM Transmission over 320km Using Both Pre- and Post-Transmission Digital Equalization

64-Tb/s, 8 B/s/hz, PDM-36QAM Transmission over 320 Km Using Both Pre- and Post-Transmission Digital Signal Processing