Abstract:This Letter proposes an approach to develop a spoof surface plasmon polariton (SSPP) transmission line (TL) by loading short-circuited (SC) shunt stubs. Lower out-of-band rejections can be flexibly controlled without affecting the upper cutoff frequency by independently modifying the stubs. Dispersion analysis of the SSPP unit is realized by theoretical calculation and circuit simulation to predict the upper cutoff frequency of the proposed SSPP TL simultaneously. Also, parametric sweeping of the SC shunt stubs is performed based on circuit simulation to investigate their impacts on the lower and upper out-of-band rejections of the proposed SSPP TL. In addition, electric field distributions of different types of TLs are simulated and compared to study the transmission characteristics of the proposed SSPP TL. The lower cutoff frequency can be flexibly tuned in a wide range, from 1.2 to 2.1 GHz, in the simulations. The measured 3-dB fractional bandwidth is about 128.1%, covering a range from 1.19 to 5.43 GHz. The numerical and experimental results are compatible, which verifies the feasibility of the proposed approach. This approach can offer more convenience and flexibility for controlling the rejections of the SSPP by introducing up to four tuning parameters. More importantly, the proposed SSPP TL avoids using the substrate integrated waveguide (SIW) technique, which shows the potential to decrease the transverse width ( 0.44 λ g ), especially at lower frequencies (e.g., 1.2 GHz), and to reduce the complexity in designing the high-efficiency transition. This work paves the way for the development of novel SSPP-based microwave devices.

Study on Roll-Off Characteristics at Upper Cutoff Frequency of SSPP Transmission Lines

Investigation of Transmission Phase of SSPP Lines with Linear Tapered Transitions

An Improved Equivalent Circuit Model of Spoof Surface Plasmon Transmission Line

Electromagnetic Wave Dispersion Curve Computation for Quasi-1D Spoof Surface Plasmon Polaritons

Transmission Loss Analysis of Grounded and Ungrounded SSPP Transmission Lines

High-Order Modes of Spoof Surface Plasmon Polaritons on Periodically Corrugated Metal Surfaces

Short-circuited Stub-Loaded Spoof Surface Plasmon Polariton Transmission Lines with Flexibly Controllable Lower Out-of-band Rejections

Compact Folded SSPP Transmission Line and Its Applications in Low-Pass Filters

Low-frequency Surface Plasmon Polaritons Propagating along a Metal Film with Periodic Cut-Through Slits in Symmetric or Asymmetric Environments

Surface Plasmon Transmission Line Based on Folded Stepped Grooves and Spiral-Shaped Structures

Spoof Surface Plasmon Polaritons Developed from SIW Using Ring Slots and Vias

Compact transition enabled broadband propagation of spoof surface plasmon polaritons based on the equivalent circuit model

Generation and Manipulation of Lower Out-of-Band Rejections of Spoof Surface Plasmon Polaritons

Broadband Propagation of High-order Mode of Spoof Surface Plasmon Polaritons Supported by Compact Complementary Structure

Characteristic Impedance Extraction of Spoof Surface Plasmon Polariton Waveguides

A Compacted 2.5-Dimensional Spoof Surface Plasmon Polaritons Transmission Line

Spoof Surface Plasmon (Ssp) Transmission Line Transition Design Using Slow-Wave Coplanar Waveguide (S-Cpw)

Compact CPW Spoof Surface Plasmon Polariton Transmission Line with Interdigital Structure

Equivalent Circuit Parameters of Planar Transmission Lines with Spoof Surface Plasmon Polaritons and Its Application in High Density Circuits.

PSO-Algorithm-Assisted Design of Compact SSPP Transmission Line