Abstract:Ni-based wrought superalloys are widely used in the hot section of aircraft gas turbine engines for their capability in retaining strength and resisting creep, fatigue, and oxidation at elevated temperature. With the development of the newer generation turbine disk alloys, it is highly imperative for aircraft engine manufacturers to substantiate the use of the materials by conducting a thorough examination of their mechanical properties. As these components are subjected to elevated temperatures and complex stress state in the service process where time dependent creep is the primary deformation failure mechanism and life-limiting factor for the component, it is of great importance to evaluate the relationship between microstructure, creep behavior and the underlying creep deformation mechanism. Therefore, the main objective of the present research aims at investigating the fundamental relationship between external creep condition and internal creep deformation mechanism in a new wrought superalloy with low stacking fault energy (SFE). In order to study the influences of the loading stress level and temperature on the creep deformation mechanism, stress range of 345-840 MPa and temperature range of 650-815 degrees C were selected to carry out the creep experiment. The results show that two kinds of gamma' with different diameters distributed in the matrix and the larger one began to coarsen when the creep temperature increased to 725 degrees C. Under creep temperature of 650 degrees C, the formation of SF resulted from the shearing of gamma' by dislocations dominated the creep deformation. When the temperature range was raised up to 725-760 degrees C, SF and microtwins were the main microstructures after creep deformation. With further increasing the temperature and load, instead of accommodating only in the gamma', the SF and microtwins penetrated the whole gamma' and matrix area. When the temperature was increased to 815 degrees C, the climb/bypass mechanism controlled the creep process.

Properties and Simulation of Nonisothermal Creep of a Directionally Solidified Superalloy

An Investigation of the Effect of High-Temperature Cyclic Straining and Creep Loading on Tensile Mechanical Properties of GH4145/SQ Alloy

Creep Behavior and Deformation Mechanism of a Third-Generation Single Crystal Ni-Based Superalloy at 980 °C

In Situ SEM Study of Creep Deformation Behavior of Nickel-Based Single-Crystal Superalloys

Creep Behavior and a Deformation Mechanism Based Creep Rate Model under High Temperature and Low Stress Condition for Single Crystal Superalloy DD5

Tensile, Creep Behavior and Microstructure Evolution of an As-Cast Ni-based K417G Polycrystalline Superalloy

Effect of Creep Process on the Microstructural Evolution and Deformation Behavior of a New Powder Metallurgy Ni-Based Superalloy

Creep Mechanism of A Ni-Co Base Wrought Superalloy

Experimental Investigation and Numerical Prediction on Creep Crack Growth Behavior of the Solution Treated Inconel 625 Superalloy

Evolution and Structure Characterization of the Carbide and Boride during Creep in A Ni-based Superalloy

Study on Creep Behaviors of GH3230 Superalloy With Side Notches or a Center Inclined Hole at 900°C and 1000°C

High Temperature Fatigue and Creep-Fatigue Behaviors in a Ni-based Superalloy: Damage Mechanisms and Life Assessment

Creep behaviors and deformation mechanisms at intermediate temperatures in a novel γ‐γ' nickel‐based superalloy

Study on high-temperature creep behavior of nickel-base single crystal supper alloy

Experimental investigation on creep strengthening phenomenon of a Ni-based single crystal superalloy under cyclic loading and unloading conditions

Connecting the Microstructure Stability of Ni Based Superalloys to Their Chemical Compositions

Impacts of different designed microstructures on creep performance of a Ni-based wrought superalloy

Study of the Creep Behavior of Nickel-Based Single Crystal Superalloy Micro Specimens with Dimensional Effects

Microstructural evolution and creep mechanism of a directionally solidified superalloy DZ125 under thermal cycling creep

Creep Properties of a Nickel-Based Single Crystal Superalloy with Low Density

Study on creep characteristics and the isochronous stress–strain curve of Ni-Cr-Mo superalloy