Abstract:Successful in situ chemical oxidation (ISCO) applications require real-time monitoring to assess the oxidant delivery and treatment effectiveness, and to support rapid and cost-effective decision making. Existing monitoring methods often suffer from poor spatial coverage given a limited number of boreholes in most field conditions. The ionic nature of oxidants ( e.g. , permanganate) makes time-lapse electrical resistivity tomography (ERT) a potential monitoring tool for ISCO. However, time-lapse ERT is usually limited to qualitative analysis because it cannot distinguish between the electrical responses of the ionic oxidant and the ionic products from contaminant oxidation. This study proposed a real-time quantitative monitoring approach for ISCO by integrating time-lapse ERT and physics-based reactive transport models (RTM). Moving past common practice, where an electrical-conductivity anomaly in an ERT survey would be roughly linked to concentrations of anything ionic, we used PHT3D as our RTM to distinguish the contributions from the ionic oxidant and the ionic products and to quantify the spatio-temporal evolution of all chemical components. The proposed approach was evaluated through laboratory column experiments for trichloroethene (TCE) remediation. This ISCO experiment was monitored by both time-lapse ERT and downstream sampling. We found that changes in inverted bulk electrical conductivity, unsurprisingly, did not correlate well with the observed permanganate concentrations due to the ionic products. By integrating time-lapse ERT and RTM, the distribution of all chemical components was satisfactorily characterized and quantified. Measured concentration data from limited locations and the non-intrusive ERT data were found to be complementary for ISCO monitoring. The inverted bulk conductivity data were effective in capturing the spatial distribution of ionic species, while the concentration data provided information regarding dissolved TCE. Through incorporating multi-source data, the error of quantifying ISCO efficiency was kept at most 5 %, compared to errors that can reach up to 68 % when relying solely on concentration data.

Monitoring Geologic Carbon Sequestration Using Electrical Resistivity Tomography

Monitoring CO2 sequestration into deep saline aquifer and associated salt intrusion using coupled multiphase flow modeling and time‐lapse electrical resistivity tomography

Application of Electrical Resistivity Tomography to Monitor the Dewatering of Vertical and Horizontal Wells in Municipal Solid Waste Landfills

Monitoring and Characterizing the Whole Process of Microbially Induced Calcium Carbonate Precipitation Using Electrical Resistivity Tomography

Real-Time Imaging and Holdup Measurement of Carbon Dioxide under CCS Conditions Using Electrical Capacitance Tomography

Advancing CO2 Storage Monitoring Via Cross-Borehole Apparent Resistivity Imaging Simulation

Geoelectrical characterisation of CO2–water systems in porous media: application to carbon sequestration

Groundwater Flow Monitoring Via Combined Time-lapse Electrical Resistivity and Self Potential Data Tomography

Electrical Resistivity Tomography in Geotechnical Engineering Applications

Cross-Borehole ERT Monitoring System for CO2 Geological Storage: Laboratory Development and Validation

Geophysical Monitoring Technologies for the Entire Life Cycle of CO2 Geological Sequestration

Geophysical monitoring technology for CO2 sequestration

Cross‐well seismic waveform tomography for monitoring CO2 injection: a case study from the Ketzin Site, Germany

Characterizing the infiltration process in low-permeable bedrock by high-density electrical resistivity tomography

Reactive Transport Modeling to Study Fluid-Rock Interactions in Enhanced Geothermal Systems ( EGS ) with CO 2 as Working Fluid

Electrical resistivity tomography through reinforced concrete floor

Real-time monitoring of in situ chemical oxidation (ISCO) of dissolved TCE by integrating electrical resistivity tomography and reactive transport modeling

Joint Monitoring of CO2-ECBM Based on Multiple Geophysical Methods: A Case Study of Shizhuang Town, Shanxi Province, China

Monitoring the Solute Transport in Static Water by Using High-density Electrical Resistivity Tomography

Spatial and Temporal Monitoring of Salt Solution Infiltration Using Electrical Resistivity Tomography

Archaeological Survey under Complex Surface Conditions by Electrical Resistivity Tomography