Abstract:Context. The observed spectra from black hole (BH) X-ray binaries (XRBs) typically consist of two primary components. A multitemperature blackbody originating from the accretion disk in the soft X-ray, and a power law-like component in the hard X-ray, due to the Comptonization of soft photons by the hot corona. The illumination of the disk by the corona gives rise to another key component known as reflection. A fraction of the incident hard X-ray radiation is naturally absorbed and re-emitted as a blackbody at lower energies and referred to as the "reprocessed blackbody". Aims. For densities relevant to XRBs and typical ionization values, the reprocessed blackbody may become significant in the soft X-ray region (approximately 0.1–1.0 keV) and should be noticeable in the observed spectra as a consequence of reflection. The absence of any blackbody component in the low/hard state of a BH XRB may not be consistent with the reflection of highly irradiating flux, observed as a power law from an appropriately dense disk of XRB. Methods. We focus on the low/hard state of the BH XRB MAXI J1820+070. In contrast to previous works, we simultaneously fit the shape and flux of the reflection spectra. This allowed us to estimate the correct density and ionization of the slab as well as the corresponding reprocessed blackbody. Results. Our fitting of the representative observation of the BH XRB low/hard state suggests that the disk may, in principle, extend very close to the BH, even though the reprocessed thermal emission (due to disk illumination) remains cold (and thus low) enough to be consistent with the data in contrast to the results of a previous study. The inner reflection component is highly ionized and its fit is primarily driven by its contribution to the continuum, rather than by the shape of the relativistic iron line. Conclusions. The reprocessed blackbody cannot help determine whether the disk extends close to the BH or not in the hard state. For this specific observation, the flux in inner reflection component turns out to be quite low with respect to the outer reflection or power law. The outflowing slab corona covering the inner region of the disk could be the plausible geometry of the source, with the underlying disk approaching near to the BH.

Impact of Ionization and Electron Density Gradients in X-ray Reflection Spectroscopy Measurements

Impact of the Reflection Model on the Estimate of the Properties of Accreting Black Holes

A Reflection Model with a Radial Disk Density Profile

Observational signatures of X-ray irradiated accretion disks

Testing the Performance and Accuracy of the RELXILL Model for the Relativistic X-ray Reflection from Accretion Disks

Impact of the Disk Thickness on X-Ray Reflection Spectroscopy Measurements

Modeling Uncertainties in X-ray Reflection Spectroscopy Measurements I: Impact of Higher Order Disk Images

Implementation of a Radial Disk Ionization Profile in the Relxill_nk Model

X-ray Reflection from the Plunging Region of Black Hole Accretion Disks

Modeling Uncertainties in X-Ray Reflection Spectroscopy Measurements. II. Impact of the Radiation from the Plunging Region

Impact of the Returning Radiation on the Analysis of the Reflection Spectra of Black Holes

Testing Relativistic Reflection Models with GRMHD Simulations of Accreting Black Holes

Towards more accurate synthetic reflection spectra: improving the calculations of returning radiation

Toward More Accurate Synthetic Reflection Spectra: Improving the Calculations of Returning Radiation

Modeling reflection spectra of super-Eddington X-ray sources

Reflection Spectra of Accretion Disks Illuminated by Disk-like Coronae

High-density reflection spectroscopy of black hole X-ray binaries in the hard state

Investigating the consistency of the shape and flux of X-ray reflection spectra in the hard state with an accretion disk reaching close to the black hole

Next Generation Accretion Disk Reflection Model: High-Density Plasma Effects

Reflection Spectra of Thick Accretion Discs