Abstract:The observed spectra from black hole (BH) X-ray binaries (XRBs) typically consist of two primary components: multitemperature blackbody (BB) originating from the accretion disk in soft X-ray, and a power-law like component in hard X-ray due to Comptonization of soft photons by the hot corona. Illumination of the disk by the corona gives rise to another key component known as reflection. A fraction of the incident hard X-ray radiation is naturally absorbed and re-emitted as a BB at lower energies, referred to as reprocessed BB. For densities relevant to XRBs and typical ionization values, the reprocessed BB may become significant in the soft X-ray region and should be noticeable in the observed spectra as a consequence of reflection. The absence of any BB component in the low/hard state of BH XRB may not be consistent with reflection of high irradiating flux observed as power-law from appropriately dense disk of XRB. We focus on the low/hard state of the BH XRB MAXI J1820+070. We simultaneously fit the shape and flux of the reflection spectra, allowing us to estimate the correct density and ionization of the slab and, correspondingly, the reprocessed BB. Our fitting suggests that the disk in principle may extend close to the BH and still the reprocessed BB due to disk illumination remains small enough to be consistent with the data as opposed to earlier study. The inner reflection component is highly ionized and its fit is primarily driven by its contribution to the continuum. The reprocessed BB cannot resolve whether the disk is extended close to the BH or not in the hard state. For this specific observation, the flux in inner reflection component turns out to be quite low with respect to outer reflection or power-law. Outflowing slab corona covering the inner region of the disk could be the possible geometry of the source with the underlying disk reaching close to the BH. (shortened)

Reflection Spectra of Thick Accretion Discs

Reflection Spectra of Accretion Disks Illuminated by Disk-like Coronae

X-ray Reflection from the Plunging Region of Black Hole Accretion Disks

Testing Relativistic Reflection Models with GRMHD Simulations of Accreting Black Holes

Modeling reflection spectra of super-Eddington X-ray sources

Observational signatures of X-ray irradiated accretion disks

Toward More Accurate Synthetic Reflection Spectra: Improving the Calculations of Returning Radiation

Impact of the Reflection Model on the Estimate of the Properties of Accreting Black Holes

Towards Precision Measurements of Accreting Black Holes Using X-Ray Reflection Spectroscopy

Towards more accurate synthetic reflection spectra: improving the calculations of returning radiation

Impact of the Disk Thickness on X-Ray Reflection Spectroscopy Measurements

Impact of Ionization and Electron Density Gradients in X-ray Reflection Spectroscopy Measurements

Impact of the Returning Radiation on the Analysis of the Reflection Spectra of Black Holes

Modeling Uncertainties in X-Ray Reflection Spectroscopy Measurements. II. Impact of the Radiation from the Plunging Region

Testing the Kerr Black Hole Hypothesis Using X-ray Reflection Spectroscopy and a Thin Disk Model with Finite Thickness

Modeling Uncertainties in X-ray Reflection Spectroscopy Measurements I: Impact of Higher Order Disk Images

A Reflection Model with a Radial Disk Density Profile

Towards a new generation of reflection models for precision measurements of accreting black holes

Investigating the consistency of the shape and flux of X-ray reflection spectra in the hard state with an accretion disk reaching close to the black hole

Next-generation Accretion Disk Reflection Model: High-density Plasma Effects

Iron line profiles and self-shadowing from relativistic thick accretion discs