Abstract:The geomagnetic components measurement directly influences the azimuth and magnetic Toolface of downhole drilling tools. Accurate estimation of the geomagnetic components is crucial for wellbore trajectory control. However, the unknown magnetic interferences caused by ferromagnetic drilling tools introduce significant errors in the estimation of the geomagnetic components. Firstly, this paper considers the constraint of a constant total magnetic field value and introduces the unknown axial interferences of the drilling tools as a new state. At the same time, parameter uncertainties and radial interferences within the drilling tools are regarded as unknown but bounded, leading to the establishment of a linear time-varying system model for the measurement system. Then, a state estimation method based on the Zonotopic Kalman Filter is proposed for geomagnetic components and attitude measurements. The simulation results indicate that, compared to the Zonotopic Kalman Filter method without considering nonlinear constraints, the method proposed in this paper effectively separates the axial interference of the geomagnetic components from the drilling tools during dynamic measurements. The root mean square errors of the estimated three-axis geomagnetic components are reduced to 0.0249 Gauss, 0.0082 Gauss, and 0.0148 Gauss, resulting in improvements in accuracy of 96.06%, 28.6%, and 14.1%, respectively. Furthermore, the root mean square errors of the gravity Toolface, magnetic Toolface, and azimuth estimation decreased to 1.8296°, 1.8294°, and 3.2898°, leading to enhancements in accuracy of 9.61%, 9.71%, and 96.37%, respectively. Finally, experimental validation confirms the effectiveness of the proposed method, providing a reference basis for dynamic measurement while drilling.

Variational Bayesian-Based Moving Horizon Estimation of Toolface for Rotary Steerable Drilling Tool Systems

Moving Horizon Estimation for Stochastic Descriptor Systems with Inaccurate Noise Covariance Matrices

Fault estimation for rotary steerable drilling tool systems with strong vibrations and unknown terms

Estimation of Toolface for Dynamic Point-the-bit Rotary Steerable Systems Via Nonlinear Polynomial Filtering.

Variational Bayesian State Space Model for Dynamic Process Fault Detection

Particle Filter-Based Fault Detection for Toolface Measurement of Rotary Steerable Systems.

Development of a Monocular Vision System for Robotic Drilling.

Moving Horizon Fault Estimation for Nonlinear Stochastic Systems with Unknown Noise Covariance Matrices

Random Weighting Adaptive Estimation of Model Errors on Attitude Measurement for Rotary Steerable System

Sensor Fault Detection and Isolation in Toolface Control of Rotary Steerable Drilling System

Prediction of Surface Topography in Robotic Ball-End Milling Considering Tool Vibration

Intermittent Fault Detection for Dynamic Point-the-Bit Rotary Steerable Drilling Tool Systems

Incipient Fault Detection of Rotary Steerable Drilling Tool Equip-Ment

Accelerometer Fault Detection for Rotary Steerable Drilling Tool Systems under Strong Noises

Estimation of Tool Wear and Surface Roughness Development Using Deep Learning and Sensors Fusion

Adaptive Fixed-Time Fault-Tolerant Tracking Control for Rotary Steerable Drilling Tool Systems

Interval estimation of sensor fault in rotary steerable drilling tools based on set-membership approach

Vision-Assisted Probabilistic Inference of Milling Stability through Fully Bayesian Gaussian Process

Estimation of geomagnetic components under unknown interferences for drilling tools

Real-Time Estimation for Cutting Tool Wear Based on Modal Analysis of Monitored Signals

Non-linear Wiener process–based cutting tool remaining useful life prediction considering measurement variability