Abstract:Conventional vehicle electronic stability control requires one steering-wheel angle sensor, one lateral acceleration sensor and one yaw rate sensor to obtain a good control performance. The control system stops working when a sensor fault is detected, which means that the vehicle runs in an unprotected state. Thus, various sensor fault diagnosis algorithms have been designed to detect and isolate the faulty sensor, but these algorithms also can be used for fault-tolerant control to preserve the safety of the vehicle. However, determining which of the different sensors is faulty is very difficult as the conventional residual comparison algorithm can only find the existence of a sensor fault but cannot locate the faulty sensor, and very few research studies have focused on this problem. In this paper, an ingenious sensor fault diagnosis algorithm is proposed. The sensor fault is detected, located and isolated by cross-checking with three different yaw rate estimates. The steering-wheel angle observer and the lateral acceleration observer are designed to provide corresponding estimated sensor signals which are employed to estimate the different yaw rates by using an extended Kalman filter. A novel decision-making process is carefully designed to locate the faulty sensor based on the different yaw rate residuals. Electronic stability control is not interrupted as the faulty sensor signal is reconfigured by the estimated signal. Experimental tests on a real car show that the proposed algorithm is efficient for detecting the sensor fault and identifying which sensor is faulty. Simulations show that the vehicle stability control strategy based on the proposed sensor fault-tolerant control algorithm has a better performance than the traditional control strategy does.

Sensor Fault Detection and Isolation in Toolface Control of Rotary Steerable Drilling System

Incipient Fault Detection of Rotary Steerable Drilling Tool Equip-Ment

Particle Filter-Based Fault Detection for Toolface Measurement of Rotary Steerable Systems.

Effective Model Based Fault Detection Scheme for Rudder Servo System

Fault Diagnosis of Hard Rock Tunnel Boring Machine Cutterhead Driving System Based on Adaptive Observers

Intermittent Fault Detection for Dynamic Point-the-Bit Rotary Steerable Drilling Tool Systems

Accelerometer Fault Detection for Rotary Steerable Drilling Tool Systems under Strong Noises

Fault estimation for rotary steerable drilling tool systems with strong vibrations and unknown terms

Sensor-Based Control Using an Image Point and Distance Features for Rivet-in-Hole Insertion.

Adaptive Fixed-Time Fault-Tolerant Tracking Control for Rotary Steerable Drilling Tool Systems

Interval estimation of sensor fault in rotary steerable drilling tools based on set-membership approach

Fault Detection and Fault-Tolerant Control of Paper Machines

Estimation of Toolface for Dynamic Point-the-bit Rotary Steerable Systems Via Nonlinear Polynomial Filtering.

Data-driven sensor fault diagnosis systems for linear feedback control loops

Sensor Fault Detection and Diagnostics of Nonlinear Systems with Application to Paper Machines

Self-Stabilizing Control Strategy of Stabilized Platform for Rotary Steerable Drilling System Based on Adaptive Backstepping Control

Model-based Sensor Fault Detection and Isolation Method for a Vehicle Dynamics Control System

A Fault Detection and Isolation Method for Independent Metering Control System Based on Adaptive Robust Observer

Tool-face Control for Slide Drilling Based on Fuzzy Sliding Mode Controller

An Adaptive Toolface Control Method for Slide Steering Drilling

Sensorless Fault-Tolerant Control of Dual Three-Phase Permanent Magnet Synchronous Motor