Abstract:Numerous attempts have been made to develop ion-exchange membranes with low resistance for various applications such as electrodialysig and fuel cells. In this study, the strategies of immersion precipitation and dry-casting were combined, to control the membrane porosity with the purpose of improving the physical and electrochemical properties of ion-exchange membranes. The porosity was tuned using the time of membrane exposure to an elevated temperature environment. In addition to controlling the porosity to balance the membrane electrical resistance with the diffusion caused by the concentration gradient, it was experimentally shown that the porosity can influence the IEC and water uptake of the membrane and, thus, further affect the resistance. Furthermore, the surface hydrophilicity was characterized by water contact angle measurements; the results revealed that the porous membranes were more hydrophilic than the dense membranes. As demonstrated by experimental data for desalination by electrodialysis, it was found that a membrane dried at 60 degrees C for 1 h had the highest desalination efficiency. This is mainly because porous membranes facilitate the transport of ions. Compared to membranes with higher porosity, the membrane prepared with a 1-h aging time had more steric hindrance, which can decrease the diffusion of ions, so that a superior desalination efficiency can be obtained. To further investigate the impact of the density of -SO32- functional groups on the electrodialysis process, membranes with various weight ratios of poly(ether sulfone) (PES) to sulfonated poly(ether sulfone) (SPES) were prepared. With increasing content of SPES, the physical and electrochemical properties of the newly developed porous membranes were changed. A membrane with higher density of functional groups was found to have a higher desalination efficiency, because of the electrostatic effect of the membrane. These results were consistent with the current efficiency. Under optimal membrane preparation conditions, the obtained membrane had a high IEC (1.75 mmol/g) and water uptake (168%). The desalination efficiency reached 95%, and the current efficiency reached 100%. It was concluded that the performance of a porous membrane with controllable porosity can enhance the electrodialysis (ED) process with respect to energy efficiency and desalination efficiency. New methods of fabricating membranes with pores such as immersion precipitation and dry-casting are thought to be potential routes to decreasing the electrical resistance.

Electrodialysis to concentrate high-salinity solutions: The matching relation between cation- and anion-exchange membranes

Fabrication of a Cation-Exchange Membrane Via the Blending of SPES/N-Phthaloyl Chitosan/MIL-101(Fe) Using Response Surface Methodology for Desalination

Effects of cation exchange membrane properties on the separation of salt from high-salt organic wastewater by electrodialysis

Influence of the ions distribution of anion-exchange membranes on electrodialysis

Influences of hydrophobic tail length tuning of linear aliphatic di-cation functioned anion exchange membrane on electrodialysis desalination

Low Energy Cost High Electrodialysis Performance Anion-Exchange Membranes for Desalination

Study on Mass Transfer Performance and Membrane Resistance in Concentration of High Salinity Solutions by Electrodialysis

A Novel Porous Asymmetric Cation Exchange Membrane with Thin Selective Layer for Efficient Electrodialysis Desalination

On the Analysis of Monovalent-Ion Selectivity of Anion-Exchange Membranes

Mono-valent Cation Selective Membranes for Electrodialysis by Introducing Polyquaternium-7 in a Commercial Cation Exchange Membrane

Cardopoly(arylene ether sulfone)s membranes bearing N-cyclic cationic groups enable high performance during both diffusion dialysis and electrodialysis

Experimental Study on Concentrating the Simulated Salt Water with Electrodialysis

Highly Permselective and Conductive Composite Anion Exchange Membranes Qpt@Pe for Electrodialysis Desalination

Surface Modification of Anion Exchange Membrane by Covalent Grafting for Imparting Permselectivity Between Specific Anions

Novel Ecofriendly Cation Exchange Membranes for Low-Cost Electrodialysis of Brackish Water: Desalination and Antiscaling Performance

Study on the Permselectivity of Ion Exchange Membrane

Sustainable Strategies of In-Series AEM Electrolysis and CEM Electrolysis for the Treatment of NF Concentrates Via Ettringite-Targeted Mineral Transition

Cation Exchange Membranes and Process Optimizations in Electrodialysis for Selective Metal Separation: A Review

Cation-Exchange Membranes with Controlled Porosity in Electrodialysis Application

Side Chain Crosslinked Anion Exchange Membrane for Acid Concentration by Electrodialysis

On the permselectivity of di- and mono-valent cations: Influence of applied current density and ionic species concentration