Abstract:Fluid viscosity is one of the key factors affecting the cavitation characteristics of the Helico-axial Multiphase Pump (HAMP). In this paper, fluids with viscosities of 24.46 mm2/s, 48.48 mm2/s, 60.70 mm2/s, and 120.0 mm2/s were investigated by numerical simulation. The Ansys Fluent software was employed to conduct the simulation. The mixture multiphase flow model and the RNG k-ε turbulence model were adopted. The Singhal cavitation model was employed to consider the effects of the non-condensable gas on cavitation. An experiment was carried out to validate the numerical method. The results showed that the Net Positive Suction Head-available (NPSHA) of the pump decreased as the fluid viscosity increased. Under the critical NPSHA condition, the NPSHA decreased from 5.11 m to 3.68 m as the fluid viscosity increased from 24.46 mm2/s to 120.0 mm2/s. This suggested that the cavitation performance of the pump was deteriorated under high fluid viscosity. The impeller passage area occupied by the vapor increased when the fluid viscosity increased. Nearly half of the flow passages were occupied by cavitation bubbles when the fluid viscosity increased to 120.0 mm2/s. The vapor volume fraction, both on the suction surface and pressure surface of the blade, increased with the fluid viscosity. The vapor on the suction surface was mainly distributed in the region with the streamwise between 0 and 0.36 when the fluid viscosity was 24.46 mm2/s; while the high vapor volume fraction range increased to the streamwise of 0.42 when the fluid viscosity increased to 120.0 mm2/s. The higher vapor volume fraction corresponded with the lower pressure. It was also found that the turbulent kinetic energy, both on the suction surface and pressure surface, increased with the fluid viscosity, which was the favorite for producing more cavitation bubbles. Furthermore, the maximum velocity area was mainly concentrated in the inlet area of the impeller. The velocity distribution in the impeller was basically the same with the viscosity of 24.46 mm2/s and 48.48 mm2/s. When the viscosity further increased to 60.70 mm2/s, the maximum velocity area in the impeller was relatively large. This study provides a reference for designing the HAMP.

Cavitation in a high-speed aviation axial piston pump over a wide range of fluid temperatures

Numerical Simulation of Cavitating Flow in Water Hydraulic Axial Piston Pump

Centrifugal Effects on Cavitation in the Cylinder Chambers for High-Speed Axial Piston Pumps

Investigation of cavitation characteristics in an aircraft centrifugal fuel pump

Analysis of Cavitation Characteristics of High Temperature Fuel Piston Pump in the Process of Suction and Discharge

Numerical Analysis Of Airfoil Naca0015 And Centrifugal Pump'S Cavitation Characteristic Based On The Thermodynamic Effects

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Investigation of the cavitation performance in an engine cooling water pump at different temperature

Application and Challenge of High-Speed Pumps with Low-Temperature Thermosensitive Fluids

The Analysis on the Cavitation Performance of a Steam Turbine Lubricating Oil Pump with Consideration of the Fluid Temperature Effect

Optimization of the Outlet Unloading Structure to Prevent Gaseous Cavitation in a High-Pressure Axial Piston Pump

Experimental and Numerical Studies on Erosion Damage in Damping Holes on the Valve Plate of an Axial Piston Pump

Numerical Simulation of Cavitation Flow under High Pressure and Temperature

Numerical Simulation of the Cavitation Characteristics of A Mixed-Flow Pump

Raising the Speed Limit of Axial Piston Pumps by Optimizing the Suction Duct

Experimental investigation of thermal effect on cavitation characteristics in a liquid rocket engine turbopump inducer

The cavitation characteristics of aerospace high-speed centrifugal pumps with different tip clearance

Influence of Fluid Viscosity on Cavitation Characteristics of a Helico-Axial Multiphase Pump (HAMP)

Study of the Cavitation Phenomenon Inside Roller Vane Pump

Effects of Inclined Cylinder Ports on Gaseous Cavitation of High-Speed Electro-Hydrostatic Actuator Pumps: a Numerical Study

Numerical Calculation on the Cavitation Performance of Axial Flow Pump in Multi-operating Conditions