Abstract:The flow and segregation behaviours of the binary mixtures with different particle sizes during die filling in air and in a vacuum were investigated using a coupled discrete element method (DEM) and computational fluid dynamics (CFD) in three dimensions (3D). Two types of computational setups were considered: i) a fully 3D model with real wall boundaries and ii) a thin sliced model with a slice of the full domain using two parallel periodic boundaries. Die filling with a stationary shoe and a moving shoe were simulated. It was found that the flow and segregation results obtained using the fully 3D and thin sliced models were essentially identical, implying that the thin sliced model can be used to simulate the die filling with a reduced computational time and good accuracy. It was also observed that, for die filling with a stationary shoe, the powder flow rate was reduced by the entrapped air in the die. For the die filling in a vacuum, vertical segregation occurred with a high concentration of fine particles at the bottom of the die as the fine particles can sift through the voids between coarse particles. The presence of air reduced the extent of this segregation by suppressing the percolation of fines through the voids. For die filling with a moving shoe, the effect of air on powder flow and segregation behaviours is negligible when the process is dominated by nose flow as considered in this study, since the air can readily escape from the die cavity. Segregation was also induced during die filling with a moving shoe, due to the free surface segregation and the filtration of fines through the voids between the coarse particles. Consequently, a high overall concentration of fines in the die was obtained, while the concentration of fines at the far end of the die was much lower than that at the near end.

CFD-DEM Study of Segregation and Mixing Characteristics under a Bi-Disperse Solid-Liquid Fluidised Bed

Experimental and numerical investigation of solid behavior in a gas–solid turbulent fluidized bed

A Numerical Investigation on Segregation in Gas-Fluidized Beds of Short, Flexible Fibers

Numerical studies of the influence of particles' size distribution characteristics on the gravity separation performance of Liquid-solid Fluidized Bed Separator

Segregation and mixing of binary mixtures of spherical particles in a bubbling fluidized bed

Numerical simulation of local and global mixing/segregation characteristics in a gas–solid fluidized bed

CFD-DEM Investigation of the Fluidization of Binary Mixtures Containing Rod-Like Particles and Spherical Particles in a Fluidized Bed

Study on a Semi-Resolved CFD-DEM Method for Rod-Like Particles in a Gas-Solid Fluidized Bed

CFD–DEM Study of Mixing and Dispersion Behaviors of Solid Phase in a Bubbling Fluidized Bed

DEM/CFD Modelling of the Deposition of Dilute Granular Systems in a Vertical Container

CFD-DEM Simulation of Fluidization of Polyhedral Particles in a Fluidized Bed

Micro-scale Simulation and Analysis of Gas-Solid Fluidized Bed with Multi-Density Distribution of Particles

Three Dimensional DEM/CFD Analysis of Segregation During Silo Filling with Binary Mixtures of Different Particle Sizes

CFD-DEM Simulation of Fluidized Bed with an Immersed Tube Using a Coarse-Grain Model

Particle-Scale Simulation of Solid Mixing Characteristics of Binary Particles in a Bubbling Fluidized Bed

Particle segregation within bidisperse turbidity current evolution

Computational Fluid Dynamics-Discrete Element Method Investigation of Solid Mixing Characteristics in an Internally Circulating Fluidized Bed

Numerical and Experimental Study of Radial Segregation of Bi-Disperse Particles in a Quasi-Two-dimensional Horizontal Rotating Drum

3D DEM/CFD analysis of size-induced segregation during die filling

Numerical Study of Particle Injection into a Gas-Solid Fluidized Bed

Numerical investigation of the particle flow behaviors in a fluidized-bed drum by CFD-DEM