Abstract:The flow and segregation behaviours of the binary mixtures with different particle sizes during die filling in air and in a vacuum were investigated using a coupled discrete element method (DEM) and computational fluid dynamics (CFD) in three dimensions (3D). Two types of computational setups were considered: i) a fully 3D model with real wall boundaries and ii) a thin sliced model with a slice of the full domain using two parallel periodic boundaries. Die filling with a stationary shoe and a moving shoe were simulated. It was found that the flow and segregation results obtained using the fully 3D and thin sliced models were essentially identical, implying that the thin sliced model can be used to simulate the die filling with a reduced computational time and good accuracy. It was also observed that, for die filling with a stationary shoe, the powder flow rate was reduced by the entrapped air in the die. For the die filling in a vacuum, vertical segregation occurred with a high concentration of fine particles at the bottom of the die as the fine particles can sift through the voids between coarse particles. The presence of air reduced the extent of this segregation by suppressing the percolation of fines through the voids. For die filling with a moving shoe, the effect of air on powder flow and segregation behaviours is negligible when the process is dominated by nose flow as considered in this study, since the air can readily escape from the die cavity. Segregation was also induced during die filling with a moving shoe, due to the free surface segregation and the filtration of fines through the voids between the coarse particles. Consequently, a high overall concentration of fines in the die was obtained, while the concentration of fines at the far end of the die was much lower than that at the near end.

Three Dimensional DEM/CFD Analysis of Segregation During Silo Filling with Binary Mixtures of Different Particle Sizes

3D DEM/CFD analysis of size-induced segregation during die filling

Numerical analysis of density-induced segregation during die filling

The effects of air and particle density difference on segregation of powder mixtures during die filling

Multi-level DEM study on silo discharge behaviors of non-spherical particles

Multi-Scale Study of Particle Flow in Silos

A Coupled DEM/CFD Analysis of Die Filling Process

DEM/CFD Modelling of the Deposition of Dilute Granular Systems in a Vertical Container

A Numerical Investigation on Segregation in Gas-Fluidized Beds of Short, Flexible Fibers

DEM Study of the Size-Induced Segregation Dynamics of a Ternary-Size Granular Mixture in the Rolling-Regime Rotating Drum

Modelling segregation of flowing bidisperse granular mixtures varying simultaneously in size and density

DEM simulation of size segregation of binary mixtures of cohesive particles under a horizontal swirling vibration

Simulation and Modeling of Segregating Rods in Quasi‐2d Bounded Heap Flow

Designing non-segregating granular mixtures

Investigation of particle segregation in a vertically vibrated binary mixture: Segregation process and mechanism

Numerical modelling of suction filling using DEM/CFD

Numerical and Experimental Study of Radial Segregation of Bi-Disperse Particles in a Quasi-Two-dimensional Horizontal Rotating Drum

CFD-DEM Investigation of the Fluidization of Binary Mixtures Containing Rod-Like Particles and Spherical Particles in a Fluidized Bed

DEM modeling of the dilute-to-dense transition of granular flow in silos

Designing minimally-segregating granular mixtures for gravity-driven surface flows

Segregation and mixing of binary mixtures of spherical particles in a bubbling fluidized bed