Abstract:Real-time measurement of heavy oil production is critical to ensure stable production. Due to the complex kinematic characteristics of heavy oil, existing methods cannot accurately measure its flow rate and water cut. In this paper, a novel method is proposed to measure the high water-cut heavy oil flow by using the differential pressure of the two-phase swirling flow in the pipe. For the swirling flow in the pipe, the radial differential pressure and the axial differential pressure exist simultaneously, which are very sensitive to the flow rate and water cut. The formation mechanism of the two kinds of differential pressure is analyzed theoretically, and their relationship with flow rate and water cut is studied by experiment and numerical simulation. The measurement model of heavy oil–water two-phase flow on the above relations is validated by field experiments. The radial differential pressure is only related to the two-phase flow rate, varying exponentially with the flow rate when the oil viscosity is greater than 10 000 mPa s. This characteristic is very useful for the heavy oil–water two-phase flow measurement. The axial differential pressure decreases with the increase in water cut in cases of water cut <85%, while it increases with the water cut in cases of water cut >85%. With the increase in water cut, the ratio of axial differential pressure to radial differential pressure first decreases and then increases. The relative errors of the established measurement model for flow rate and water cut are 0.19%–17.92% and 0.21%–15.5%, respectively, and more than 70% of the measurements with a relative error of less than 10%. The study of the heavy oil–water two-phase flow measurement method can optimize the measurement cost and accelerate the process of intelligent oilfield construction.

Measurement of High-Water-content Oil-Water Two-Phase Flow by Electromagnetic Flowmeter and Differential Pressure Based on Phase-Isolation

Oil-water two-phase flow measurement based on a hybrid flowmeter and dominant phase identification

Measurement of Inclined Oil–Water Two-Phase Flows with the Combination of Electromagnetic Flowmeter and Differential Pressure Sensor

Oil-Gas-Water Three-Phase Flow Measurement Based on the Theory of Partial Separation

Oil-water two-phase flow measurement based on differential pressure

Measurement of Vertical Oil-in-water Two-Phase Flow Using Dual-Modality ERT–EMF System

Measurement of Oil–Gas–Water Flows in Vertical Pipes Using Electromagnetic Flowmeter and Dual-Conductance Sensors

Gas-liquid two-phase flow measurements by the electromagnetic flowmeter combined with a phase-isolation method

Differential Pressure Method for Measuring Water Holdup of Oil–water Two-Phase Flow with Low Velocity and High Water-Cut

Development of Online Real Time Water Content Meter Based on Phase Method

Measurement of high water-cut heavy oil flow based on differential pressure of swirling flow

The Performance Characteristics of Electromagnetic Flowmeter in Vertical Low-Velocity Oil-Water Two-Phase Flow

Flow Measurement of Oil-in-Water Emulsions Using Arc-Type Conductivity Probes and Electromagnetic Flowmeter

Novel Downhole Electromagnetic Flowmeter for Oil-Water Two-Phase Flow in High-Water-Cut Oil-Producing Wells.

Experimental Studies on the Measurement of Oil-water Two-phase Flow

The Ultrasonic Measurement of High Water Volume Fraction in Dispersed Oil-in-water Flows

Measurement of Vertical Gas-Liquid Two-Phase Flow by Electromagnetic Flowmeter and Image Processing Based on the Phase-Isolation

Mass Flow Measurement of Oil-Water Two-Phase Flow Based on Coriolis Flow Meter and SVM

Flow Rate Measurement of Oil-Gas-water Wavy Flow Through a Combined Electrical and Ultrasonic Sensor

Measurement of the water-to-liquid ratio of oil-water two-phase flow for low flow rates and high water content

New Measurement Method of Oil-Water Two-Phase Flow with High Water Holdup and Low Rate by Phase State Regulation