Abstract:Ni-based wrought superalloys are widely used in the hot section of aircraft gas turbine engines for their capability in retaining strength and resisting creep, fatigue, and oxidation at elevated temperature. With the development of the newer generation turbine disk alloys, it is highly imperative for aircraft engine manufacturers to substantiate the use of the materials by conducting a thorough examination of their mechanical properties. As these components are subjected to elevated temperatures and complex stress state in the service process where time dependent creep is the primary deformation failure mechanism and life-limiting factor for the component, it is of great importance to evaluate the relationship between microstructure, creep behavior and the underlying creep deformation mechanism. Therefore, the main objective of the present research aims at investigating the fundamental relationship between external creep condition and internal creep deformation mechanism in a new wrought superalloy with low stacking fault energy (SFE). In order to study the influences of the loading stress level and temperature on the creep deformation mechanism, stress range of 345-840 MPa and temperature range of 650-815 degrees C were selected to carry out the creep experiment. The results show that two kinds of gamma' with different diameters distributed in the matrix and the larger one began to coarsen when the creep temperature increased to 725 degrees C. Under creep temperature of 650 degrees C, the formation of SF resulted from the shearing of gamma' by dislocations dominated the creep deformation. When the temperature range was raised up to 725-760 degrees C, SF and microtwins were the main microstructures after creep deformation. With further increasing the temperature and load, instead of accommodating only in the gamma', the SF and microtwins penetrated the whole gamma' and matrix area. When the temperature was increased to 815 degrees C, the climb/bypass mechanism controlled the creep process.

Effects of Stacking Fault Energy and Temperature on Creep Performance of Ni-based Alloy with Different Co Contents

Effects of Stacking Fault Energy on the Creep Behaviors of Ni-Base Superalloy

Creep Mechanisms of a Ni-Co-Based-Wrought Superalloy with Low Stacking Fault Energy

Creep Mechanism of A Ni-Co Base Wrought Superalloy

Stacking fault energy and creep mechanism of a single-crystal nickel-based superalloy

Dynamic Strain Aging in Ni Base Alloys with Different Stacking Fault Energy

Creep mechanisms of a new Ni-Co-base disc superalloy at an intermediate temperature.

Creep Behavior and Deformation Mechanism of a Third-Generation Single Crystal Ni-Based Superalloy at 980 °C

In Situ SEM Study of Creep Deformation Behavior of Nickel-Based Single-Crystal Superalloys

High-Ti inducing local Eta-phase transformation and creep-twinning in CoNi-based superalloys

Influence of Ta Content on Microstructure and Creep Behavior of a Ni–Co Base Disc Superalloy

Temperature Effects on Deformation Substructures and Mechanisms of a Ni-based Single Crystal Superalloy

Effects of Microstructure on the Creep Properties of A New Ni-Co Base Superalloy

Effects of Alloying Elements on the Stacking Fault Energies of Ni58Cr32Fe10 Alloys: A First-Principle Study

Effect of alloying elements on stacking fault energies of γ and γʹ phases in Ni-based superalloy calculated by first principles

Stacking fault effects on dynamic strain aging in a Ni–Co-based superalloy

An in situ ambient and cryogenic transmission electron microscopy study of the effects of temperature on dislocation behavior in CrCoNi-based high-entropy alloys with low stacking-fault energy

Creep behaviors of fine-grained Ni-base powder metallurgy superalloys at elevated temperatures

Effect of γ' phase and microtwins on the microstructural evolution and mechanical properties of a novel Ni–Co base superalloy

Understanding creep of a single-crystalline Co-Al-W-Ta superalloy by studying the deformation mechanism, segregation tendency and stacking fault energy

Effects of stacking fault energy on the deformation behavior of CoNiCrFeMn high-entropy alloys: A molecular dynamics study