Abstract:The application of ceramic dielectrics in various microwave electronic instruments and devices is determined by their properties such as dielectric constant, dielectric loss factor, thermal conductivity, and absorptance. Alumina nitride composites with dielectric losses (high dielectric loss tangent tgδ varying from 0.1 to 0.6 ) are promising functional materials, but there are few publications with detailed dielectric characteristics including thermal conductivity, which is especially important for devices with high output power. To determine the dielectric characteristics (ε′ and tgδ), the resonance measurement method with a cylindrical resonator was employed. The electromagnetic energy absorptance L (attenuation in a bulk absorber with respect to absorber length) was used to compare absorbers of different sizes. Microwave attenuation in the absorber ring located in a resonator of the delay line of the traveling-wave tube model was measured employing a P2-61 panoramic meter for voltage standing wave ratio and attenuation. Experimental values of the real and imaginary ε′′ parts of the complex dielectric constant in pressureless-sintered AlN–SiC composites with different contents and sizes of semiconducting silicon carbide particles are presented. When SiC increases from 20 to 50% in the AlN-based composite, ε′ becomes 1.7–2.1 times higher and ε′′ 5.4–6.8 times higher. The smaller the SiC particles, the greater the increase in ε′ and ε′′, silicon carbide content being the same. The relationship between the thermal conductivity and electromagnetic energy absorptance in the AlN–SiC composites was studied. The range of compromise values was found: they combine relatively high thermal conductivity, 45–55 W/(m · K), and significant absorptance, L = 2.8–3.5 dB/mm, corresponding to the highest silicon carbide content (40–50%) and microsized SiC particles (2.3–4.4 μm). A relationship was established between the imaginarabsorptance L(dB/mm) , allowing the absorptance to be determined from known ε′′ at a frequency of 3.3 GHz.

Energy absorption performances of silicon carbide particles during microwave heating process

Heating Performances of Corn Straw Particle With/without SiC Particle in a Microwave Chamber.

Microwave Heating of Silicon Carbide and Polypropylene Particles in a Fluidized Bed Reactor

Microwave Absorbability of Unidirectional SiC Fiber Composites As a Function of the Constituents’ Properties

Temperature distribution of SiC bed surface in a large-scale microwave-assisted pyrolysis reactor

Microstructure and Microwave Absorption Performance Variation of SiC/C Foam at Different Elevated-Temperature Heat Treatment

Microwave heating and mechanism for seed-induced synthesis of SiC

Dielectric response and microwave absorption properties of SiCw/SiCf composites derived from carbon fiber

Effect of SiC nanowires on the high-temperature microwave absorption properties of SiCf/SiC composites

Studies of synthesizing the SiC nanometer powders by chemical vapor reaction

Mechanical and microwave absorption properties of Ti-filled SiCf/SiC composites via precursor infiltration and pyrolysis

Influence of the Silicon Carbide Particle Size on Dielectric Characteristics, Thermal Conductivity, and Microwave Absorption of Pressureless-Sintered AlN–(20–50)% SiC Composites

Study on Electromagnetism Parameter and Microwave Absorption Properties of SiC Absorber

Molten-salt-mediated synthesis of SiC nanowires for microwave absorption applications

High-temperature Microwave Absorbing Properties of Ordered Mesoporous Inter-Filled SiC/SiO2 Composites

In situ investigation of SiC powder’s microwave sintering by SR-CT technique

Microwave absorption performance of porous heterogeneous SiC/SiO2 microspheres

Preparation and high-temperature microwave absorbing properties of 6H-SiC/MWCNT/silicon resin composites

Microwave-absorption Properties of Heterostructural SiC Nanowires/sioc Ceramic Derived from Polysiloxane

Simultaneously Enhancing Mechanical and Microwave Absorption Properties of Cf/SiC Composites Via SiC Nanowires Additions

Experimental Fluidization Performances of Silicon Carbide in a Fluidized Bed