Abstract:Purpose – The employment of continuous ribs in a passage involves a noticeable pressure drop penalty, while other studies have shown that truncated ribs may provide a potential to reduce the pressure drop while keeping a significant heat transfer enhancement. The purpose of this paper is to perform computer-aided simulations of turbulent flow and heat transfer of a rectangular cooling passage with continuous or truncated 45-deg V-shaped ribs on opposite walls. Design/methodology/approach – Computational fluid dynamics technique is used to study the fluid flow and heat transfer characteristics in a three-dimensional rectangular passage with continuous and truncated V-shaped ribs. Findings – The inlet Reynolds number, based on the hydraulic diameter, is ranged from 12,000 to 60,000 and a low-Re k-e model is selected for the turbulent computations. The local flow structure and heat transfer in the internal cooling passages are presented and the thermal performances of the ribbed passages are compared. It is found that the passage with truncated V-shaped ribs on opposite walls provides nearly equivalent heat transfer enhancement with a lower (about 17 percent at high Reynolds number of 60,000) pressure loss compared to a passage with continuous V-shaped ribs or continuous transversal ribs. Research limitations/implications – The fluid is incompressible with constant thermophysical properties and the flow is steady. The passage is stationary. Practical implications – New and additional data will be helpful in the design of ribbed passages to achieve a good thermal performance. Originality/value – The results imply that truncated V-shaped ribs are very effective in improving the thermal performance and thus are suggested to be applied in gas turbine blade internal cooling, especially at high velocity or Reynolds number.

Thermal test and numerical simulation of cooling stave with internal ribbed tube

Structure Optimization of Water Cooling Channel of Cast Steel Stave

Numerical simulation of steel-copper-steel composite cooling staves: Heat transfer characteristics and structural optimization

Heat Transfer Analysis for Staves with Cooling Water Pipes of Different Shape

Design and Optimization of Air Pre-Heater with Internally Ribbed Tube

Heat Transfer Analysis of Cooling Stave Based on Thermal State Experiment

The study of structure optimization of blast furnace cast steel cooling stave based on heat transfer analysis

The Effect of Cooling Conditions on Convective Heat Transfer and Flow in a Steam-Cooled Ribbed Duct

Film Cooling Performance and Flow Characteristics of Internal Cooling Channels with Continuous/truncated Ribs

Numerical Investigations Of Cooling Enhancement With Internal Ribs And External Coolant Film

Heat transfer analysis of blast furnace stave

INFLUENCE OF STRUCTURAL PARAMETERS ON STEADY-STATE HIGHEST TEMPERATURE AND THERMAL STRESS OF BF COOLING STAVE

Numerical Study on the Effect of Different Internal Angled Ribs on the External Film Cooling Performance

Experimental study on cooling performance of a steam-cooled turbine blade with five internal cooling smooth channels

The study of cooling channel optimization in blast furnace cast steel stave based on heat transfer analysis

Study on Conjugate Thermal Performance of a Steam-Cooled Ribbed Channel with Thick Metallic Walls

Experimental study on characteristics of water icing outside tube with wave-like internal fins

Numerical Analysis on the Heat Transfer Characteristics of Supercritical Water in Vertically Upward Internally Ribbed Tubes

Numerical Investigation of Fluid Flow Structure and Heat Transfer in A Passage with Continuous and Truncated V-Shaped Ribs

An Experimental Investigation of Heat Transfer Characteristics in a Steam-Cooled Square Channel with Rib Turbulators

Performance Optimization Criterion of Blast Furnace Stave