Abstract:Ni nanoparticles supported on ZrO2 are a prototypical system for reforming catalysis converting methane to synthesis gas. Herein, we examine this catalyst on a fundamental level using a 2-fold approach employing industrial-grade catalysts as well as surface science based model catalysts. In both cases we examine the atomic (HRTEM/XRD/LEED) and electronic (XPS) structure, as well as the adsorption properties (FTIR/PM-IRAS), with emphasis on in situ/operando studies under atmospheric pressure conditions. For technological Ni-ZrO2 the rather large Ni nanoparticles (about 20 nm diameter) were evenly distributed over the monoclinic zirconia support. In situ FTIR spectroscopy and ex situ XRD revealed that even upon H2 exposure at 673 K no full reduction of the nickel surface was achieved. CO adsorbed reversibly on metallic and oxidic Ni sites but no CO dissociation was observed at room temperature, most likely because the Ni particle edges/steps comprised Ni oxide. CO desorption temperatures were in line with single crystal data, due to the large size of the nanoparticles. During methane dry reforming at 873 K carbon species were deposited on the Ni surface within the first 3 h but the CH4 and CO2 conversion hardly changed even during 24 h. Post reaction TEM and TPO suggest the formation of graphitic and whisker-type carbon that do not significantly block the Ni surface but rather physically block the tube reactor. Reverse water gas shift decreased the H2/CO ratio. Operando studies of methane steam reforming, simultaneously recording FTIR and MS data, detected activated CH4 (CH3 and CH2), activated water (OH), as well as different bidentate (bi)carbonate species, with the latter being involved in the water gas shift side reaction. Surface science Ni-ZrO2 model catalysts were prepared by first growing an ultrathin "trilayer" (O-Zr-O) ZrO2 support on an Pd3Zr alloy substrate, and subsequently depositing Ni, with the process being monitored by XPS and LEED. Apart from the trilayer oxide, there is a small fraction of ZrO2 clusters with more bulk-like properties. When CO was adsorbed on the (fully metallic) Ni particles at pressures up to 100 mbar, both PM-IRAS and XPS indicated CO dissociation around room temperature and blocking of the Ni surface by carbon (note that on the partially oxidized technological Ni particles, CO dissociation was absent). The Ni nanoparticles were stable up to 550 K but annealing to higher temperatures induced Ni migration through the ultrathin ZrO2 support into the Pd3Zr alloy. Both approaches have their benefits and limitations but enable us to address specific questions on a molecular level.

DNP NMR Reveals the Hidden Surface C-C Bond Growth Mechanism over ZnAlOx During Syngas Conversion

Synergistic interplay of dual active sites on spinel ZnAl2O4 for syngas conversion

Zirconia-Supported ZnO Single Layer for Syngas Conversion Revealed from Machine-Learning Atomic Simulation

Activation of CO and Surface Carbon Species for Conversion of Syngas to Light Olefins on ZnCrO -Al2o3 Catalysts

First-principles-based microkinetic simulations of syngas to methanol conversion on ZnAl2O4 spinel oxide

Revealing Interaction of Pyridinic N in N-doped Carbon with Sn Sites for Improved CO2 Reduction

A method for surface characterization using solid-state nuclear magnetic resonance spectroscopy demonstrated on nano-crystalline ZnO:Al

Reaction-driven surface reconstruction of ZnAl2O4 boosts the methanol selectivity in CO2 catalytic hydrogenation

Unravelling the Impact of Metal Dopants and Oxygen Vacancies on Syngas Conversion over Oxides: A Machine Learning-Accelerated Study of CO Activation on Cr-Doped ZnO Surfaces

Unveiling the Surface Structure of ZnO Nanorods and H2 Activation Mechanisms with 17O NMR Spectroscopy

Unveiling the Anti-Trap Effect for Bridging Intermediates on ZnAlOx/AlPO-18 Bifunctional Catalysts to Boost Syngas to Olefin Conversion

Insights into the Mn-doping effects on the catalytic performance of ZnCrAlO y /SAPO-34 bifunctional catalyst for the direct conversion of syngas to light olefins

Visualization of the Active Sites of Zinc-Chromium Oxides and the CO/H2 Activation Mechanism in Direct Syngas Conversion

C−C Bond Formation in Syngas Conversion over Zinc Sites Grafted on ZSM‐5 Zeolite

Surface Spectroscopy on UHV-Grown and Technological Ni-ZrO2 Reforming Catalysts: From UHV to Operando Conditions

Nanocatalysts Anchored on Nanofiber Support for High Syngas Production Via Methane Partial Oxidation

Identifying the Active Site on ZnxCryOz for HC-O Bond Cleavage in Syn-gas Conversion

A Novel Ni–MoCxOy Interfacial Catalyst for Syngas Production Via the Chemical Looping Dry Reforming of Methane

Revealing the crystal facet effect on N2O formation during the NH3-SCR over α-MnO2 catalysts

Dynamic chemical processes on ZnO surfaces tuned by physisorption under ambient conditions

A mechanistic study of syngas conversion to light olefins over OXZEO bifunctional catalysts: insights into the initial carbon–carbon bond formation on the oxide