Effect of Carbon Content of Substrate on the Microstructure Changes and Tensile Behavior of Clad Layer of Stainless Steel Composites

Bingnan Wu,Kai Guo,Xiaoyu Yang,Yunzhe Gao,Yulong Jin,Yuwei Gao,Qingfeng Wang,Fucheng Zhang
DOI: https://doi.org/10.1016/j.msea.2021.142201
2022-01-01
Abstract:This work aims to estimate the effect of interfacial carbon diffusion on the diffusion behavior of interfacial Cr element, interfacial microstructure, and tensile behavior of stainless steel (SS) composites. Here, 316L SS was selected as the clad material, and two low-alloyed steels (LASs) with different carbon contents (0.06 and 0.20 wt %) were used as the substrate. Two SS composites were prepared via vacuum hot compression in a Gleeble-3500 simulator, followed by normalization treatment. The results revealed that as the carbon content increases, the zone of the decarburized and the carburized of the composite sample become wider. The M23C6 carbides precipitated at the grain boundaries of the carburized zone of SS clad increase, and their morphology transformed from discontinuously granular to continuously lamellar. Therefore, the ultimate tensile strength (UTS) and yield strength (YS) were also increased. Simultaneously, the uniform elongation decreased from 24% to 17% due to the formation of local microcracks at the intergranular lamellar carbides.
What problem does this paper attempt to address?