Abstract:The Cu materials are playing an irreplaceable role in modern marine facilities, while one major issue affecting their service life is corrosion attack caused by external erosion of chloride ions, which leads to the quickly structural deterioration and reduced durability. To solve this obstinate issue, the corrosion−resistant Ni−based composite films with conductive Yttria–stabilized zirconia (YSZ, 2.5–15 g/L) and non−conductive Si 3 N 4 (2.5–15 g/L) reinforcing phases were composite–electrodeposited on Cu substrate in direct current (DC) mode. It was believed that the electrical differences of incorporated nanoparticles have a significant impact on nucleation and growth behaviors during electrodeposition, which further altered the structure and property of Ni−based composite films. Therefore, the emphasis of this study was to establish the correlation between obtained structure, electrochemical, and immersion corrosion performances at different incorporation levels of YSZ/Si 3 N 4 nanoparticles. The results demonstrate that by increasing the total doping contents, the Electrochemical Impedance Spectroscopy (EIS) and Chronoamperometry (CA) measurements exhibited an initial increase followed by a subsequent decrease on co−deposition dynamics, which was related to the dominant impact of conductive YSZ nanoparticle at electrocrystallization process. Meanwhile, the moderate incorporation level of 15 g/L offered effective control over structural compactness through dispersion−strengthening and grain−refining, and the same ratio of YSZ/Si 3 N 4 nanoparticles further maximized the improvement degree of microhardness, electrochemical passivation, and immersion stability of resulting films. Besides, the corrosion current density ( j corr ) of Ni−YSZ−Si 3 N 4 composite coating under optimum condition of 15 g/L was two orders of magnitude smaller than that of Cu substrate after long−term immersion test, and the corresponding polarization resistance ( R p ) also increased by 8.6 times. Overall, these substantial alterations obtained provide effective guideline for the design and preparation of corrosion−resistant Ni−based composite coating, which is beneficial to prolonging the service life of Cu components in saline environments.

Preparation of electrochemically deposited nickel-cobalt nanocomposite coating and research on its corrosion resistance

Electrodeposition and corrosion performance of Ni-Co alloys with different cobalt contents

Preparation and application of nano-Ni–Co alloy

Investigation on the Corrosion and Oxidation Resistance of Ni-Al2O3 Nano-Composite Coatings Prepared by Sediment Co-Deposition

Codeposition Behavior of Fe-Ni Alloys: A Review in Mechanisms, Preparation and Effects on Composition

Preparation of Composite Nickel Coatings on AZ31B Magnesium Alloy and the Corrosion Resistance Investigation

Microstructure evolution and improved corrosion resistance of electrodeposited NiCo-Al composite coatings with different Al contents

Preparation and characterization of nickel nano-Al2O3 composite coatings by sediment co-deposition

Electrodeposition fabrication of corrosion−resistant Ni–based composite film on surface of Cu: Role of conductive YSZ and non−conductive Si 3 N 4 nanoparticles

Preparation and characterisation of the Ni-C composite coating electrodeposited with carbon sol

Electrochemical behavior and electro-crystallization mechanism of Cu-Ni/Nano-Al 2 O 3 coating with a deposition current density dependence

Sediment co-deposition of nanostructured Ni-Al2O3 composite coatings

Electrochemical co-deposition of Nickel-Alumina Nanocomposite for Microsystem Applications

Microstructural Characterization and Corrosion Behaviors of Ni-Cu-Co Coatings Electrodeposited in Sulphate-Citrate Bath with Additives

Electrochemical Behavior and Electro-Crystallization Mechanism of Cu-Ni/Nano-Al2O3 Coating with a Deposition Current Density Dependence

The Process for Electroplating of Zinc-Nickel Alloy Coating and Corrosion Resistance of the Coating

Fabrication and Characterization of Ni-Al2o3 Nano-Composite Coatings by Sediment Co-Deposition

Corrosion Behavior of Ni-P-Nano-Al2o3 Composite Coating in the Presence of Anionic and Cationic Surfactants

Mechanical and Corrosion-Resistance Performance of Electrodeposited Titania–nickel Nanocomposite Coatings

Electrochemical Deposition and Corrosion Resistance Characterization of FeCoNiCr High-Entropy Alloy Coatings

Pulse Electrodeposition of Ni-Co 3 O 4 Nanocomposite Layer and Investigation of Its Structure and Properties