Abstract:Droplet evaporation coupled with gravity and surface tension on a wall with the radial temperature gradients is numerically studied with the arbitrary Lagrangian‒Eulerian method. The influence of the wall temperature distribution on the droplet evaporation process, which is less considered in the existing literature, is mainly discussed. The droplet temperature coefficient of the surface tension and the viscosity on the droplet profile evolution, flow, heat and mass transfer characteristic are also discussed. The results indicate that the droplets become flat first and then retract under the gravity and Marangoni convection during droplet evaporation. There are two high-velocity regions inside the evaporating droplet. One region is at the droplet axis, in which fluid flows to the wall from the droplet top. The other region is near the droplet surface, where fluid flows to the droplet top. There are turning points on the two sides of which the influence of wall temperature distribution on the ratio between the droplet height and the radius of the three-phase contact line (h/Rc), the velocity in the droplet and the surface temperature converts. All of them are larger before the turning point when the wall temperature slope is positive. After the turning point, these are reversed. For both h/Rc and average surface temperature, there is one turning point, which are t*=1.63×10-4 and t*=1.05×10-4, respectively. For maximum velocity and average velocity in droplet, there are two turning points, which are both t*=1.63×10-4 and t*=1.7×10-5. The droplet morphology changes more obviously when it is with a greater temperature coefficient of surface tension. Moreover, the turning point is delayed from t*=6.41×10-5 while α is 8 K/m to t*=7.91×10-5 while α is -8 K/m, which indicates that the negative wall temperature slope is beneficial to inhibit the Marangoni effect on droplet evaporation.

Study of Sessile Droplet Evaporation on Wall with Radial Temperature Gradient

Sessile Droplet Evaporation on Wall with Radial Temperature Gradient

Evaporation of sessile droplet on surfaces with various wettability

Direct Numerical Simulations of Sessile Droplet Evaporation on a Heated Horizontal Surface Surrounded by Moist Air

Temperature Distribution Along The Surface Of Evaporating Droplets

Theoretical Analysis of a Sessile Evaporating Droplet on a Curved Substrate with an Interfacial Cooling Effect

Criterion for Reversal of Thermal Marangoni Flow in Drying Drops

Three-Dimensional Numerical Simulation on Marangoni Convection in a Sessile Water Droplet Evaporating in Its Vapor at Low Pressure

THE EXPERIMENTAL STUDY OF SINGLE DROPLET IMPINGING ON AN INCLINED HEATED WALL

Numerical simulation of evaporation and heat transfer of droplet impacting on cylindrical outer surface

Study on evaporation induced flow characteristics and interfacial phenomena of water in a sidewall-heated cylindrical pool at low pressures

Boiling evaporation characteristics of sessile droplets and its transition evaporation mode

Impingement dynamics of droplets on mildly heated walls at initial and later stages

Radial-Velocity Profile along the Surface of Evaporating Liquid Droplets

“Phase Diagram” of Surface Temperature Distribution of Sessile Droplets and the Effects of Evaporative Cooling

Evaporation of sessile water droplets on horizontal and vertical bi-phobic patterned surfaces

Simulation of droplet evaporation under the dual influence of surface wettability and nucleate boiling

CFD simulation on droplet behaviour in post-dryout region

Dropwise Condensation Heat Transfer Coefficient on the Horizontal Circular Surface with Radial Gradient Surface Energy

Numerical simulation of moving droplets on vertical walls

Numerical Study On Evolution Of Sessile Water Droplets During Evaporation