Abstract:Dynamic surface wetting of particles in contact with droplet is a complex phenomenon ubiquitously encountered in many multiphase systems of industrial importance. In this study, we address this aspect by investigating impact behavior of a water droplet (diameter = 2.9 ± 0.1 mm) in the Weber number (We) range from ~4 to 104 on a stationary spherical brass particle (diameter = 10 mm) with and without heat transfer using a combination of high speed imaging and computational fluid dynamics (CFD) modeling approach. In cold state interactions (20°C), droplet exhibited oscillatory interfacial motion comprising periodic spreading and recoiling motion. Interactions involving heat transfer were studied in film boiling regime (350°C) and two outcomes were noted-droplet rebound and disintegration. A coupled Level Set and Volume of Fluid (VOF) approach based multiphase CFD model was utilized to predict the dynamic spread ratio and transient evolution of droplet shape during the interaction. To capture the complex contact line motion realistically, a continuous time varying profile of experimentally measured dynamic contact angles was used as a wall boundary condition for the cold interactions which provided good agreement with experimentally measured droplet spread ratio. In film boiling regime, droplet spread ratio was correlated to impact Weber number and a power law trend was obtained. Rebound and disintegration outcomes were characterized by the droplet-particle contact time. For simulating interactions in film boiling regime, a constant contact angle in the limit of super-hydrophobic surface was implemented in the CFD model to account for the apparent non-wetting effect due to vapor film formation at the contact area. A sensitivity analysis was performed involving three different contact angle boundary conditions (θ s = 150, 160, and 170°) to represent the surface hydrophobicity. CFD model predicted interaction outcomes and droplet spread ratios were in reasonable agreement with the experiment at different impact Weber numbers. Increase in spherical surface heat flux and corresponding rise in droplet temperature at different impact Weber numbers were also quantified which showed an increasing trend up to a critical Weber number for droplet disintegration.

CFD simulation on droplet behaviour in post-dryout region

The Interaction Between Droplet Evaporation and Turbulence with Interface-Resolved Direct Numerical Simulation

CFD Simulation of Multiphase Droplet Evaporation

Droplet Evaporation to Boiling in Van Der Waals Fluid

Simulation of Mass and Heat Transfer of Droplets Collision in a Flash Evaporation Pattern

Experiment on local convective heat transfer for successive droplets impacting on heated cylindrical surface

Experimental study on the secondary droplet formation mechanism when droplet impacting on superheated surface

The condensation characteristics of individual droplets during dropwise condensation

Dynamic characteristics of droplet impact on heated surfaces near Leidenfrost temperature

Evolution and heat transfer after droplet impact on heated liquid film with vapor bubbles inside

Numerical study on heat and mass transfer of droplet collision on superheated bio-inspired surfaces

Dynamic Behavior of Droplet Impact on Laminar Superheated Particles

Sessile Droplet Evaporation on Wall with Radial Temperature Gradient

Experimental study on the dryout heat flux of falling liquid film

Dynamic Surface Wetting and Heat Transfer in a Droplet-Particle System of Less Than Unity Size Ratio

Influence Region Theory of the Evaporating Droplet

Interfacial phenomena and heat transfer associated with multi-droplet impact on flowing liquid film

Numerical simulation of droplet impinging icing process on a low-temperature wall with smoothed particle hydrodynamics (SPH) method

Experimental study of two-phase heat transfer of droplet impact on liquid film

Simulation of droplet evaporation under the dual influence of surface wettability and nucleate boiling

Evaporation of sessile droplet on surfaces with various wettability