Effect of Cyclic Water Injection on the Wettability of Coal with Different SiO2 Nanofluid Treatment Time

Tiancheng Zhang,Quanle Zou,Xueqi Jia,Ting Liu,Zebiao Jiang,Shixiang Tian,Chengzi Jiang,Yanying Cheng
DOI: https://doi.org/10.1016/j.fuel.2021.122922
IF: 7.4
2021-01-01
Fuel
Abstract:Coal seam water injection is proved an effective method for preventing coal and gas outburst. However, the poor wettability of coal seam has resulted in poor effect of coal seam water injection in preventing coal and gas outburst. In addition, the coal seam is in a state of injected-uninjected cycle due to multiple water injection. Therefore, it is important to study the wettability of coal seam with adding wetting agent under multiple water injection. In this paper, the effect of cyclic water injection on the wettability of coal with different SiO2 nanofluid treatment times was investigated through contact angle tests. The results showed that increasing the treatment time of SiO2 nanofluid would enhance the wettability of coal. In addition, the wettability of nanofluid-treated coal samples gradually got worse with the number of cycles increasing. In general, the effect of SiO2 nanofluid on enhancing the wettability was approximately 2 to 4.5 times better than that of water. However, the difference of wetting enhancement between water and SiO2 nanofluid became less obvious as the number of cycles increased. Even though, the nanofluid-treated coal samples showed the better wettability than water-treated coal samples after 13th cycle. Furthermore, the potential application of SiO2 nanofluid in coal seam water injection was proposed, which had important significance for improving the effectiveness of coal seam water injection.
What problem does this paper attempt to address?