Abstract:Optical fibers are drawn from preforms (fused silica glass rods) typically made up of two concentric cylinders (the core rod and the clad tube), which are usually joined in a separate fusion process. The setup time and hence manufacturing cost can be significantly reduced if the two cylinders can be joined in the same furnace in which the fiber is drawn. A good understanding of the transient temperature distribution is needed for controlling the feed rate to avoid thermally induced cracks. Since direct measurement of the temperature fields is often impossible, the geometrical design of the preform and the control of the feed rate have largely been accomplished by trials-and-errors. The ability to predict the transient temperature distribution and the thermally induced stresses will provide a rational basis to design optimization and feed rate control of the process. In this paper, we present an analytical model to predict the transient conductive-radiative transfer as two partially joined, concentric glass cylinders with specular surfaces are fed into the furnace. Finite volume method (FVM) is used to solve the radiative transfer equation (RTE). The specular surface reflectivity is obtained by the Fresnel’s law and the Snell’s law. The boundary intensities are obtained through the coupling of the interior glass radiative transfer and the exterior furnace enclosure analysis. The model has been used to numerically study the transient conductive-radiative transfer in the advanced melting zone (AMZ) of an optic fiber drawing process. This problem is of both theoretical and practical interest in the manufacture of optical fibers. The computational method for the radiation transfer developed in this paper can also be applied to the simulation of the fiber drawing process and other glass-related manufacturing processes.

A Radiation-Temperature Coupling Model of the Optical Fiber Attenuation Spectrum in the Ge/P Co-Doped Fiber

Roughness-induced Radiation Losses in Optical Micro or Nanofibers.

Study of an Unsaturated PbSe QD-Doped Fiber Laser by Numerical Simulation and Experiment

Optical Fiber Index Taper–Theoretical Analysis and Experiment Demonstration

Novel tapered optical fiber coupler

Effect of Steady-state and Transient Γ Radiation on Ge-doped Quartz Optical Fiber

Study on lasing wavelength of free-running ytterbium-doped fiber lasers

Modeling of Load Responses and Aging of High Strength Fibers Considering UV-radiation

Novel fiber taper for efficient optical interconnection

Multiparameter-dependent Spontaneous Emission in PbSe Quantum Dot-Doped Liquid-Core Multi-Mode Fiber

Analysis of a tunable single mode optical fiber coupler

Temperature Effect on Colloidal PbSe Quantum Dot-Filled Liquid-Core Optical Fiber

Modeling of Advanced Melting Zone for Manufacturing of Optical Fibers

Comparative Investigation of Gamma Radiation Effects on Long Period Gratings and Optical Power in Different Optical Fibers

Model and Experimental Study on Optical Fiber CT Based on Terfenol-D

Modeling of the Influence of Coupling in Optical Microfiber Resonators

Numerical Analysis of Coupling from Core Mode to Radiation Mode in Long Period Fiber Gratings

Hydrogen Concentration Dependence Of Bragg Wavelength Of Uv-Written Fiber Grating

B/Ge Co-Doped Photosensitive Fiber with Suppression of Cladding Mode Coupling

Potential of Germano-phosphosilicate Single Mode Optical Fibers for Dosimetry

General Coupled-Mode Analysis for Gain-Guided, Index-Antiguided Fibers, and Index-Guided Fibers