Abstract:Combustion reaction plays an important role in heat transfer of boundary layer of solid rocket motor. In the present study, a transient numerical model is developed to investigate the influence of coupled combustion reaction on heat transfer in boundary layer of the segregated oxidizer/fuel solid motor (SOFSM). The results show that conjugate heat transfer characteristics of non-reacting flow are distinct from those of the reacting flow with coupled combustion. The reacting flow with coupled combustion renders higher and more homogeneous temperature and velocity compared with the non-reacting flow. Due to the effect of combustion heat release on thermophysical properties of the gas phase species, the heat transfer coefficient and effective thermal conductivity of the reacting flow are much higher than those of the non-reacting flow. When the combustion time increases, the heat transfer coefficients decrease in the reacting and non-reacting flows due to reduced flow velocity and lower O2 concentration. The Nusselt number (Nu) of the reacting flow is also higher than that of the non-reacting flow. Significant decrease of Nu is found in the non-reacting flow with combustion time. However, the Nu varies very slightly along the flow direction in the reacting flow. As pressure increases from 1.5 MPa to 5.0 MPa, the high-temperature area becomes narrower and the flow velocity decreases in the combustion channel. The diffusion and mixing of the oxidizer and fuel gas along the radial direction are thus weakened in the coupled combustion flow. The total heat transfer coefficient decreases from 295.88 W m−2 K−1 to 46.52 W m−2 K−1 and Nu decreases from 36.27 to 16.56 with increase of pressure. The distribution of total heat transfer coefficient is found to be highly synchronous to the distribution of regression rate of coupled combustion process. The distribution of heat transfer coefficient directly affects parallel regression and coupled combustion of the TAGN propellant. The fitting relationship of Nu, i.e., Nu = 0.058Re 0.6 Pr 0.424 is obtained for the coupled combustion flow in the motor, which provides better insight into the heat transfer in the SOFSM system.

Heterogeneous Reaction and Homogeneous Reaction Coupled Combustion Process and Mechanism of N-Decane on Partially Packed Bed Combustor

Heterogeneous Reaction and Homogeneous Flame Coupled Combustion Behavior of N-Decane in a Partially Packed Catalytic Bed Combustor

Direct numerical simulations of rich premixed turbulent n-dodecane/air flames at diesel engine conditions

Combustion characteristics change induced by n-decane catalytic reactions and its effects on the coupled combustion occurrence

Simulation of Hetero/homogeneous Combustion Characteristics of CH4/air in a Half Packed-Bed Catalytic Combustor

Impact of Intermediate Species in Simulating Oblique Detonation with Pre-Vaporized N-Decane/air Mixtures Substituting for Kerosene/Air Mixtures

Direct Numerical Simulations and Analysis of Three-Dimensional N-Heptane Spray Flames in a Model Swirl Combustor

Simplification of Pyrolytic Reaction Mechanism and Turbulent Heat Transfer of N-Decane at Supercritical Pressures

Multi-timescale Modeling of Ignition and Flame Regimes of N-Heptane-air Mixtures Near Spark Assisted Homogeneous Charge Compression Ignition Conditions

Numerical Simulation for Combustion of Droplet with Volume of Fluid Formulation

Investigation on N-Decane-hydrogen Laminar Combustion Characteristics Using the Constant Volume Combustion Method

Analysis on ignition and extinction of n-heptane in homogeneous systems

Coupling ReaxFF molecular dynamics with computational fluid dynamics on the enhanced heat sink of n-decane decomposition initiated by nitroethane in the regenerative cooling channels

Experimental and kinetic modeling study of pyrolysis and oxidation of n -decane

The effect of coupled combustion reaction on conjugate heat transfer in boundary layer of a segregated oxidizer/fuel solid motor

Experiments on N-Heptane Combustion with Two Types of Catalyst Layouts

Combustion Behavior of n-Decane in a Scramjet Model Combustor

Numerical Study on the Ignition Process of N-Decane/Toluene Binary Fuel Blends

Chemical kinetic simulation of kerosene combustion in an individual flame tube

Two-way coupled turbulent particle-laden boundary layer combustion over a flat plate