Abstract:During the operation progress of solid oxide fuel cell (SOFC), the performance and endurance are two major concerns significantly affected by gas flowing, charge transport, and chemical reaction. This paper presents a thorough research on the key parameters related to syngas and charge transport in the SOFC to reveal the intrinsic influence mechanism, including electro conductibility, gas mixture concentration, CH 4 component ratio, temperature, and anode thickness, which is instrumental in improving the operational efficiency and applicability of SOFC. Firstly, the theoretical models of charge transport and multi-component mass transfer are established, respectively, and the two are coupled using the reaction rate calculation method. Then, employing an innovative combination of the representative elementary volume (REV) scale lattice Boltzmann method (LBM) and the finite-difference LBM, the potential and multi-component gases distributions are simulated to calculate the evaluated indicators, namely activation and concentration overpotential. Finally, considering various operational conditions, the simulation experiments are conducted to investigate the parametric effect on the performance of SOFC fueled by syngas. The results demonstrate that compared to the direct reforming way, the external syngas with lower CH 4 component ratio is more favorable to the SOFC and the optimal ratio should be controlled within 0.2. The higher concentration of gas mixture and lower anode thickness both contribute to weakening the effect of concentration polarization. Especially, the performance of SOFC is improved when the concentration is 15 mol‧m −3 and the anode thickness is below 1.05 mm. With the increment of conductivity and operating temperature, the consumption of H 2 gradually increases, enhancing the efficiency of reaction gas and reducing the economic cost. And the optimal operation temperature of SOFC is about 1073 K. Moreover, the anode thickness is a trade-off between the electrochemical reaction conditions of anode and cathode, as its variation affects both of them.

Effect of Gas Flow Configurations on the Performance of MOLB-type SOFC

Effect of Rib Width and Cathode Thickness On the Performance of MOLB-Type SOFC

Influence of Flow Type on Solid Oxide Fuel Cell Performance

Effects of Methane Pre-Reforming Percentage and Flow Arrangement on the Distribution of Temperature and Thermal Stress in Solid Oxide Fuel Cell

Numerical Study of Temperature Distribution in Tubular Segmented-in-series SOFC with Co-Flow and Counter-Flow Arrangements

A novel flow field design with flow re-distribution for advanced thermal management in Solid oxide fuel cell

Effect of Operation Parameters on the Thermal Characteristics in a Planar Solid Oxide Fuel Cell

Performance Comparison on Cross-Flow and Counter-Flow Planar Solid Oxide Fuel Cell

Numerical Investigation of Heat/Flow Transfer and Thermal Stress in an Anode-Supported Planar SOFC

Effect of Radial Flows in Fuel Channels on Thermal Performance of Counterflow Tubular Solid Oxide Fuel Cells

Comparative Performance Investigation of Different Gas Flow Configurations for a Planar Solid Oxide Electrolyzer Cell

Numerical Simulation of Electrical Performance and Distribution of SOFC Stacks with Different Manifold Arrangement

Numerical Study on Thermoelectric Performance of Cross-Flow Planar Solid Oxide Fuel Cell

A numerical study of the performance of solid oxide fuel cell with bi-layer interconnector

Experimental investigation of temperature distribution in solid oxide fuel cells

Parametric Study for Electrode Microstructure Influence on SOFC Performance

Parametric analysis of solid oxide fuel cell fueled by syngas based on lattice Boltzmann method

Effect of syngas flow rate on the performance of solid oxide fuel cell

Structure optimization and thermal field analysis of biogas derived methane fueled Solid Oxide Fuel Cell

Numerical study on a novel SOFC with bi-layer interconnector

Comparison and optimization of electrochemical and thermal performances of SOFC with different configurations of a metal foam flow field