Laboratory Experimental Study on Pumping-Induced Earth Fissures

Zhang Yun,He Guofeng,Wu Jichun,Yu Jun,Gong Xulong
DOI: https://doi.org/10.1007/s10040-022-02473-w
2022-01-01
Hydrogeology Journal
Abstract:The mechanisms associated with pumping-induced earth fissures have so far been unclear. To gain an insight into the mechanisms, a physical model test was conducted, which included a pumping well and a ridge of bedrock. There were two soil layers in the model box—the lower one was sand and the upper one was silty clay. When groundwater was pumped through the system, both pore-water pressure change and soil deformation were found to be three-dimensional. The pore-water pressure in the pumped sand layer decreased rapidly when pumping started, while that in the neighboring clay layer increased in the early pumping time and then gradually decreased with pumping. The bedrock ridge hindered water in the sand layer from flowing towards the pumping well and reduced water replenishment from a constant head boundary, resulting in an unusual distribution of pore-water pressure. The vertical compaction of the clay layer changed with different sites, and the greatest occurred over the bedrock ridge. The greatest vertical strain occurred in the zone between the pumping well and bedrock ridge, as did the maximum surface horizontal displacement and horizontal strain within the soils. The number and the size of fissures increased with pumping. Earth fissures mainly developed in the area between the pumping well and the projection of the bedrock ridge, and most fissures trended approximately in parallel with the ridge. The pumping-induced fissures result mainly from the failure caused by differential horizontal and vertical soil deformation due to pumping and bedrock upheaval.
What problem does this paper attempt to address?