Abstract:Falling water film flow on large-scale curved dome of passive containment, of which the data is very scarce, plays a crucial role for the thermal-hydraulic behaviors of passive containment cooling system (PCCS) in advanced nuclear power plant. It exhibits a developing phenomenon in nature because of continuous changes of the inclined angle, the width and the extend angle of the flow channel in the longitudinal direction. In order to examine the influences of these continuously varying factors on the flow characteristics, the film thickness of free falling water flow on a large-scale ellipsoidal surface with continuously varying inclined angle and extend angle has been measured experimentally. The working fluid is the low hardness municipal water, of which the inlet temperature is the same as ambient environment. Capacitive non-contact displacement transducers, Micro-Epsilon capaNCDT-CS10 sensors, are used to measure the film thickness at different locations with inclined angle ranging from 18° to 76°. The range of the film Reynolds number is from 360 to 2175. Detailed analyses on the relationship between the dimensionless film thickness and the film Reynolds number at different longitudinal positions on the dome surface are carried out. No obvious influence on the evolution of falling film caused by the continuous changes of the inclined angle, the width and the extend angle of flow channel on the dome can be observed. A new empirical correlation of film thickness on the ellipsoid dome surface is suggested based on the data obtained in the present experiments. Most of experimental data points fall in the range of ±15% around its prediction. Comparisons are also made between the suggested correlation with other theoretical or empirical correlations of film thickness in straight channels reported in the literature, as well as the numerical results on curved surface by computational fluid dynamics software COMMIX and GASFLOW-MPI. Fairly good agreements are observed, proving that the suggested correlation can predict the film thickness on the curved dome surface of PCCS with much accuracy and then provide a more reliable basis for further analysis of the conjugate heat and mass transfer of PCCS.

Study of Film Thickness Characteristics on the Inclined Plate

Experimental and Numerical Investigation on Gravity-Driven Film Flow over Triangular Corrugations

Comparative Study on the Characteristics of Film Flow with Different Corrugation Plates

A laser interferometric measurement on the melt film thickness during close-contact melting on an isothermally-heated horizontal plate

Investigation of the flow characteristics of a falling film along an inclined surface with planar laser-induced fluorescence method

Experimental and Numerical Investigations of Film Flow Behaviors in Resonance Section over Corrugated Plates

Flow Characteristics of Film Flow over 3D Corrugations Column Plate

Wave Characteristics of Falling Film on Inclination Plate at Moderate Reynolds Number

Study on the film thickness and surface wave velocity of the thin liquid film formed by a round jet obliquely impinging on a horizontal plate

Effect of structural parameters of corrugated plate on the evolution of solitary waves and liquid film thickness distribution

Experimental Study and Numerical Simulation on Falling Film Thickness Outside a Horizontal Tube

An Investigation of Falling Liquid Films on A Vertical Heated/Cooled Plate

Thermal Imaging Study on the Surface Wave of Heated Falling Liquid Films

Piv application for the investigation of isothermal liquid film flow falling down an inclined plate

Influence of Marangoni Effect on Heated Falling Films

Thickness Distribution and Fluctuation Characteristics of Liquid Falling Film under Turbulent Conditions

Thin liquid film flow and heat transfer under spray impingement

On the transition to dripping of an inverted liquid film

Film thickness of free falling water flow on a large-scale ellipsoidal surface

Numerical Simulation On Heat Transfer Of Falling Film Flow Along A Vertical Wall

Numerical Study of the Forced Convective Condensation on a Short Vertical Plate