Abstract:A Ti bearing interstitial-free steel was finishing rolled in the ferrite region with and without lubrication and microstructures, mechanical properties and textures evolution during warm rolling and subsequent annealing were investigated by OM, SEM, tensile test and ODF. The results show that the surface microstructure of the as-rolled specimen without lubrication is composed of dense shear bands, while the microstructures of the central layer of the as-rolled specimen without lubrication and the whole cross section of the as-rolled specimen with lubrication are elongated ferrite. Short-time annealing can make the non-lubricated rolling sample recrystallize, but the lubricated rolling sample cannot. After complete recrystallization, the microstructure of the surface layer of the as-annealed specimen without lubrication is finer than that of the center layer of the as-annealed specimen without lubrication and the whole section of the as-annealed specimen with lubrication. The mechanical properties of as-annealed sample without lubrication change significantly in the initial annealing stage, while that of as-annealed sample with lubrication remain unchanged until the end stage of annealing. The surface layers of the as-rolled samples have strong Goss component and weak γ fibre components, while the central layers have strong γ fibre components and moderate rotated cubic components. As annealing proceeds, the Goss components of the surface layer decrease and the γ fibre components increase. The rotated cubic components in the central layer are gradually transformed into γ texture.

Investigation on Rolling Contact Fatigue of 55 Medium-Carbon Steel

Analysis of the Influence of Contact Stress on the Fatigue of AD180 High-Carbon Semi-Steel Roll

Rolling Contact Fatigue Crack Initiation in Medium Carbon Bainitic Steel

Effect of Primary Carbides on Rolling Contact Fatigue Behaviors of M50 Bearing Steel

Influence of warm rolling temperature on multi-scale lamellar structure and mechanical properties of medium carbon steel

The effect of retained austenite on rolling/sliding contact fatigue of high carbon steel

Effects of carburizing and nitriding sequential treatment on rolling contact fatigue of M50NiL bearing steel

Investigation into Rolling Contact Fatigue Performance of Aerospace Bearing Steels

Effect of warm surface rolling on fatigue property of H13 steel

Influence of original microstructure on rolling contact fatigue property of D2 wheel steel

The Influence of Controlled Rolling and Cooling on Microstructure and Mechanical Properties of Marine Steel

Study on Microstructure and Fatigue Properties of A473M Stainless Steel Strengthened by Surface Rolling

Investigation of oxide scale on ferritic stainless steel B445J1M and its tribological effect in hot rolling

Investigation of the Influence of Deep Rolling on the Thermal Fatigue Cracking for Aisi H13 Steel

An Investigation of Friction Coefficient on Microstructure and Texture Evolution of Interstitial-Free Steel during Warm Rolling and Subsequent Annealing

Fatigue and recrystallization evolution of carbide-free bainitic layer under high-stress rolling sliding contact

Rolling Contact Fatigue Life and Spall Propagation Characteristics of AISI M50, M50 NiL, and AISI 52100, Part III: Metallurgical Examination

Dynamic Compressive Mechanical Behavior and Microstructure Evolution of Rolled Fe-28Mn-10Al-1.2C Low-density Steel

Microstructural-based analysis of the unexpected differences in rolling contact fatigue behavior between SAE52100 and SAE4320

Microstructure Evolution of a Hypereutectoid Pearlite Steel under Rolling-Sliding Contact Loading