Abstract:Hydraulic fracturing techniques are often applied to form permeability enhancement zones near boreholes and/or wellbores in tight low-permeability reservoirs to improve their extraction efficiency. As conventional hydraulic fracturing techniques often generate high breakdown pressure and induced seismic potential, novel alternative production enhancement techniques (such as pulse hydraulic pressurization) have been proposed. However, their applicability requires further verification. Therefore, this study conducted hydraulic fracturing tests of coal under three test schemes: conventional hydraulic fracturing (CHF), stepwise pressurization hydraulic fracturing (SPHF), and stepwise pulse pressurization hydraulic fracturing (SPPHF), considering the true triaxial stress state of an actual coal seam. The results showed that the breakdown pressure of coal decreased with an increase in the horizontal stress difference ( σ 2 - σ 3 ). Moreover, the pulse pressurization produced more intergranular fractures and caused a large number of particles to be conducted as a stress concentrator at the fracture tip spalling, which promoted the unstable propagation of fractures, which decreased the breakdown pressure of coal. The abnormally high breakdown pressure in the SPHF experiments is likely due to the obstruction of high σ 2 to the fracture propagation rate and fluid injection, which intensifies the fluid hysteresis effect and the stable fracture development and expansion during the pressure-maintaining stage, thus increasing the breakdown pressure. To describe the relationship between the variation in the breakdown pressure and fracture evolution characteristics, we introduced the equivalent characteristic length l and established a breakdown pressure prediction model based on the tensile stress criterion, which shows effective prediction of the breakdown pressure in different test schemes. Anisotropic principal strain appeared under different injection schemes. During the CHF and SPHF experiments, fluid injection deformed the σ 1 direction by compression and the σ 3 direction by expansion. In the σ 2 direction, the deformation transitioned from expansion at a low stress level to compression at a high stress level. The deformation in the σ 2 direction was always compressive in the SPPHF experiments. Continuous and pulse pressurizations can promote the deformation and fracture development. For the fracture morphology, the coal in the CHF experiments was dominated by a single tensile fracture, and macroscopic shear fractures were formed in the SPHF and SPPHF experiments owing to the continuous stimulation of fluid pressure to the bonding of particles and the weak surface structure, such as bedding and cleats during the pressure maintenance and pulse, and the fragmentation effect was significant and accompanied by obvious particle spalling.

Influence of Viscoelastic Surfactant Fracturing Fluids on Modified Coal Fracture Flow Characteristics

Fracture permeability damage and recovery behaviors with fracturing fluid treatment of coal: An experimental study

Role of VES-based fracturing fluid on gas sorption and diffusion of coal: An experimental study of Illinois basin coal

Physicochemical Effect on Coal Pores of Hydrocarbon Chain Length and Mixing of Viscoelastic Surfactants in Clean Fracturing Fluids

Influences of clean fracturing fluid viscosity and horizontal in-situ stress difference on hydraulic fracture propagation and morphology in coal seam

Experimental study on deformation and fracture characteristics of coal under different true triaxial hydraulic fracture schemes

Experimental study and analysis on physicochemical properties of coal treated with clean fracturing fluid for coal seam water injection

Supercritical CO2 Soaking Effect on the Permeability of Coal Fracture Under Shear Slip

Evaluating the changes of sorption and diffusion behaviors of Illinois coal with various water-based fracturing fluid treatments

A New Mode of Visible Fracture System in Coal Seams and Its Implications for Coalbed Methane Seepage

The Influence of Fracturing Fluid on CBM Desorption-Diffusion-Seepage Capacity of Coal

Experimental study of the influence of water-based fracturing fluids on the pore structure of coal

Cracks Propagation and Permeability Enhancement Caused by Supercritical CO 2 and Water Fracturing in Natural Coal–Rock Combination

Investigation of the influence of gas fracturing on fracturing characteristics of coal mass and gas extraction efficiency based on a multi-physical field model

Experimental study on the influence of acid fracturing fluid on coal wettability

Microstructure evolution of bituminite and anthracite modified by different fracturing fluids

Fracture stiffness evaluation with waterless cryogenic treatment and its implication in fluid flowability of treated coals

Experimental investigation on coal pore-fracture variation and fractal characteristics synergistically affected by solvents for improving clean gas extraction

Rheology of high-temperature resistant fracturing fluids formed by VES, acids and oxidants for enhancing CO 2 injection in deep coal seams

A fluid–solid coupling model for hydraulic fracture of deep coal seam based on finite element method

A Discrete Fracture Modeling Approach for Analysis of Coalbed Methane and Water Flow in a Fractured Coal Reservoir