Abstract:Hydraulic fracturing techniques are often applied to form permeability enhancement zones near boreholes and/or wellbores in tight low-permeability reservoirs to improve their extraction efficiency. As conventional hydraulic fracturing techniques often generate high breakdown pressure and induced seismic potential, novel alternative production enhancement techniques (such as pulse hydraulic pressurization) have been proposed. However, their applicability requires further verification. Therefore, this study conducted hydraulic fracturing tests of coal under three test schemes: conventional hydraulic fracturing (CHF), stepwise pressurization hydraulic fracturing (SPHF), and stepwise pulse pressurization hydraulic fracturing (SPPHF), considering the true triaxial stress state of an actual coal seam. The results showed that the breakdown pressure of coal decreased with an increase in the horizontal stress difference ( σ 2 - σ 3 ). Moreover, the pulse pressurization produced more intergranular fractures and caused a large number of particles to be conducted as a stress concentrator at the fracture tip spalling, which promoted the unstable propagation of fractures, which decreased the breakdown pressure of coal. The abnormally high breakdown pressure in the SPHF experiments is likely due to the obstruction of high σ 2 to the fracture propagation rate and fluid injection, which intensifies the fluid hysteresis effect and the stable fracture development and expansion during the pressure-maintaining stage, thus increasing the breakdown pressure. To describe the relationship between the variation in the breakdown pressure and fracture evolution characteristics, we introduced the equivalent characteristic length l and established a breakdown pressure prediction model based on the tensile stress criterion, which shows effective prediction of the breakdown pressure in different test schemes. Anisotropic principal strain appeared under different injection schemes. During the CHF and SPHF experiments, fluid injection deformed the σ 1 direction by compression and the σ 3 direction by expansion. In the σ 2 direction, the deformation transitioned from expansion at a low stress level to compression at a high stress level. The deformation in the σ 2 direction was always compressive in the SPPHF experiments. Continuous and pulse pressurizations can promote the deformation and fracture development. For the fracture morphology, the coal in the CHF experiments was dominated by a single tensile fracture, and macroscopic shear fractures were formed in the SPHF and SPPHF experiments owing to the continuous stimulation of fluid pressure to the bonding of particles and the weak surface structure, such as bedding and cleats during the pressure maintenance and pulse, and the fragmentation effect was significant and accompanied by obvious particle spalling.

Fracture stiffness evaluation with waterless cryogenic treatment and its implication in fluid flowability of treated coals

Cryogenic fracturing of synthetic coal specimens under true-triaxial loadings-An experimental study

3D modeling of cryogenic cracking by liquid nitrogen in coal under true triaxial stresses

Deformation-Failure Characteristics of Coal with Liquid CO2 Cryogenic-Freezing Process: An Experimental and Digital Study

Effect of Liquid Nitrogen Cooling and Heating on Mechanical Properties and Acoustic Emission Characteristics of Coal

Rock mechanical properties of coal in cryogenic condition

Laboratory Study of Liquid Nitrogen Cryo-Fracturing as an Environmentally Friendly Approach for Coalbed Methane (CBM) Reservoirs

Mechanical damage mechanism of frozen coal subjected to liquid nitrogen freezing

Investigation of dynamic fracture behavior and energy dissipation of water-bearing coal under impact load

The evolution process of fractures and their modification effects on the liquid–solid interface during liquid nitrogen cyclic freeze–thaw of coal and shale

Damage law and mechanism of coal-rock joint structure induced by liquid nitrogen at low temperature

Mechanism and Model Analysis of Ultralow-Temperature Fluid Fracturing in Low-Permeability Reservoir: Insights from Liquid Nitrogen Fracturing

Mechanical Characterization of the Frozen and Thawed States of Coal after the Action of LN2 at In Situ Formation Pressure

Experimental study on deformation and fracture characteristics of coal under different true triaxial hydraulic fracture schemes

Influences of clean fracturing fluid viscosity and horizontal in-situ stress difference on hydraulic fracture propagation and morphology in coal seam

Liquid Nitrogen’s Effect on the Mechanical Properties of Dried and Water-Saturated Frozen Coal

Influence of liquid nitrogen cooling on Brazilian splitting characteristic of coal and sandstone

Fracture permeability damage and recovery behaviors with fracturing fluid treatment of coal: An experimental study

Study on damage characteristics and influence scope of coal-rock saturated with freeze–thaw water

Nano-CT measurement of pore-fracture evolution and diffusion transport induced by fracturing in medium-high rank coal

Study on the Dispersion Characteristics of Coal Complex Resistivity under the Effect of Liquid Nitrogen Cyclic Freeze-Thaw and Evaluation of Permeability Enhancement