Effects of polyoxymethylene dimethyl ethers (PODEn) on soot characteristics in isooctane inverse diffusion flames
Abid Ali,Hang Ren,Bingkun Wu,Chen Chen,Kaixuan Yang,Yaoyao Ying,Dong Liu
DOI: https://doi.org/10.1016/j.fuel.2024.131466
IF: 7.4
2024-07-01
Fuel
Abstract:Polyoxymethylene dimethyl ethers (PODEn, n = 1–3) such as dimethoxymethane (DMM) and PODE3 are considered highly promising alternative fuels due to their lack of C–C bonds and significant oxygen contents. Particularly, PODE3-blends with diesel have been proven to substantially reduce soot emissions and fuel consumption rates under optimized engine conditions, although the impact on soot nanostructure properties remains unclear. This study explored the effects of DMM and PODE3 on soot characteristics in isooctane (i-octane) inverse diffusion flames, focusing on soot morphology, soot nanostructure, soot nanocrystallite, and soot spectral features. To compare soot particles behavior, DMM and PODE3 blended as the isooctane substitute (by 20% and 40% volumetric fractions) were examined with various diagnostic techniques, including high-resolution transmission electron microscopy (HRTEM), X-ray diffraction (XRD), Raman spectroscopy, and X-ray photoelectron spectroscopy (XPS).The results showed that DMM and PODE3 contributed to a reduction in sooting tendency from i-octane flames, whereas the average soot mass decreased significantly as the PODE3 ratio increased, consistent with a higher oxygen concentration. Therefore, 20% PODE3/i-octane exhibited growing disorganized arrangements of soot particles with shorter fringes, smaller crystallite sizes, and a relatively lower degree of graphitization than 20% and 40% DMM additions. However, XPS analysis indicated that soot produced from PODE3/i-octane mixtures had less oxygen atoms because PODE3 has multiple –CH2O- chain groups that can convert oxygen into carbon monoxide with little soot production. However, HRTEM, XRD, and Raman spectra analyses of 40% PODE3-doped flames confirmed an exceptional correlation with turbostratic soot structure, as manifested by the shortest fringe length, longest fringe tortuosity, more amorphous soot with the smallest crystallite dimensions, and least degree of graphitization.
energy & fuels,engineering, chemical