Effects of 1-Pentanol, Methyl Butyrate and Polyoxymethylene Dimethyl Ether on Soot Formation in Isooctane Inverse Diffusion Flames
Abid Ali Hang Ren Bingkun Wu Chen Chen Runtian Yu Mingxiao Chen Yaoyao Ying Dong Liu a MIIT Key Laboratory of Thermal Control of Electronic Equipment,School of Energy and Power Engineering,Nanjing University of Science and Technology,Nanjing,Chinab Advanced Combustion Laboratory,School of Energy and Power Engineering,Nanjing University of Science and Technology,Nanjing,China
DOI: https://doi.org/10.1080/00102202.2024.2439507
IF: 1.9
2024-12-13
Combustion Science and Technology
Abstract:This paper investigates the effects of 1-pentanol, methyl butyrate (MB), and polyoxymethylene dimethyl ether (PODE 3 ) additions on soot formation in isooctane inverse diffusion flames under oxygen-enriched combustion, with a particular emphasis on the physicochemical characteristics of soot particles. Isooctane was used as the baseline fuel, with 40% and 60% volumetric fractions of 1-pentanol, MB, and PODE 3 added to evaluate the soot particle behaviors comparatively in the post-flame space, which were examined using quartz-based sampling followed by transmission electron microscopy (TEM), high-resolution transmission electron microscopy (HRTEM), Raman spectroscopy, and X-ray photoelectron spectroscopy (XPS). The sooting tendency of isooctane flames was reduced with the addition of 1-pentanol compared to MB, which can be attributed to its lower molecular weight and higher H/C ratio. In contrast, the minimum average soot mass was observed with PODE 3 additions, associated with its higher oxygen content. The results revealed that increasing amounts of 1-pentanol, MB, and PODE 3 added to isooctane decreased fringe length, increased tortuosity, and reduced graphitization levels in the soot particles. However, the 40% PODE 3 /isooctane mixture resulted in shorter fringe length, smaller crystallite dimensions, and a lower degree of graphitization than 1-pentanol and MB additions. Therefore, TEM, HRTEM, XRD, Raman, and XPS analyses indicated that soot particles generated from a higher PODE 3 ratio show a translucent film-like liquid morphology with a compact turbostratic structure, as evidenced by the shortest fringe length, highest tortuosity, smallest crystallite sizes, and a more amorphous nature with the least amount of graphitization.
energy & fuels,engineering, chemical,thermodynamics, multidisciplinary