Abstract:Balancing interfacial stability and Li+ transfer kinetics through surface engineering is a key challenge in developing high-performance battery materials. Although conformal coating enabled by atomic layer deposition (ALD) has shown great promise in controlling impedance increase upon cycling by minimizing side reactions at the electrode–electrolyte interface, the coating layer itself usually exhibits poor Li+ conductivity and impedes surface charge transfer. In this work, we have shown that by carefully controlling postannealing temperature of an ultrathin ZrO2 film prepared by ALD, Zr4+ surface doping could be achieved for Ni-rich layered oxides to accelerate the charge transfer yet provide sufficient protection. Using single-crystal LiNi0.6Mn0.2Co0.2O2 as a model material, we have shown that surface Zr4+ doping combined with ZrO2 coating can enhance both the cycle performance and rate capability during high-voltage operation. Surface doping via controllable postannealing of ALD surface coating layer reveals an attractive path toward developing stable and Li+-conductive interfaces for single-crystal battery materials.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.nanolett.0c03778?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.nanolett.0c03778</a>.Quasi in situ X-ray photoelectron spectroscopy (XPS) characterizations of Zr 3d and Ni 2p (Figure S1), XPS characterizations of O 1s (Figure S2), energy-dispersive spectroscopy (EDS) mapping of 50-ZrO2-700 °C-NCM (Figure S3), cross-sectional scanning electron microscopy (SEM) images of SC-NCM and 5-ZrO2-NCM electrode collected after 50 cycles (Figure S4), reproducible cycle and rate performance of 5-ZrO2-500 °C-NCM (Figure S5), XPS characterizations of F 1s (Figure S6), SEM characterizations of SC-NCM; 5-ZrO2-NCM; 5-ZrO2-500 °C-NCM; 5-ZrO2-700 °C-NCM after 50 cycles (Figure S7), cycle stability of NCM cathodes at 1 C (180 mA/g) in this study compared to literature reports (Table S1) (<a class="ext-link" href="/doi/suppl/10.1021/acs.nanolett.0c03778/suppl_file/nl0c03778_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Surface Reconstruction of Ni‐Rich Layered Cathodes: in Situ Doping Versus Ex Situ Doping

Mitigation of Cation Mixing of LiNiO2-based Cathode Materials by Li-doping for High-Performing Lithium-Ion Battery

Dual Modification Strategy for Enhanced Cycling and Rate Performance of Ni-Rich Cathode Materials in Lithium-Ion Batteries

Reducing structural degradation of high-voltage single-crystal Ni-rich cathode through in situ doping strategy

Optimized in Situ Doping Strategy Stabling Single-Crystal Ultrahigh-Nickel Layered Cathode Materials

Integrated Surface Modulation of Ultrahigh Ni Cathode Materials for Improved Battery Performance

Enabling Structure/Interface Regulation for High Performance Ni‐Rich Cathodes

Modifying surface chemistry and stress concentration to enable highly stable ultrahigh-Ni cathodes

Enabling high energy lithium metal batteries via single-crystal Ni-rich cathode material co-doping strategy

Enhancing the Cycling and Rate Performance of Ni-Rich Cathodes for Lithium-Ion Batteries by Bulk-Phase Engineering and Surface Reconstruction

Enhancing the Electrochemical Performance and Structural Stability of Ni-Rich Layered Cathode Materials via Dual-Site Doping

Simultaneous Enhancement of Interfacial Stability and Kinetics of Single-Crystal LiNi 0.6 Mn 0.2 Co 0.2 O 2 through Optimized Surface Coating and Doping

Surface Doping to Enhance Structural Integrity and Performance of Li‐Rich Layered Oxide

Synergistic Effect of B-Nb Co-modified to Achieve Crystal Structure and Interface Tuning for Ni-rich Cathode

Aluminum and Indium Co‐Modified Ni‐Rich Layered Cathode with Enhanced Microstructure and Surface Stability for Lithium‐Ion Batteries

Surface Gradient Ni‐rich Cathode for Li‐ion Batteries

Doping‐Induced Surface and Grain Boundary Effects in Ni‐Rich Layered Cathode Materials

Surface enrichment and diffusion enabling gradient-doping and coating of Ni-rich cathode toward Li-ion batteries

Fast Charge Storage Kinetics by Surface Engineering for Ni-Rich Layered Oxide Cathode

Elevating Cycle Stability and Reaction Kinetics in Ni‐Rich Cathodes Through Tailored Bulk and Interface Chemistry for Sulfide‐Based All‐Solid‐State Lithium Batteries

Enhanced electrochemical performance of Ni-rich cathode material by N-doped LiAlO2 surface modification for lithium-ion batteries