Abstract:When a pole-to-pole dc fault occurs in a multi-terminal HVDC system, it is desirable that the stations and dc solid-state transformers on healthy cables continue contributing to power transfer, rather than blocking. To reduce the fault current of a modular multilevel converter based dc solid-state transformer, active fault current control is proposed, where the dc and ac components of fault arm currents are regulated independently. By dynamically regulating the dc offset of the arm voltage rather than being set at half the rated dc voltage, the dc component in the fault current is reduced significantly. Additionally, reduced ac voltage operation of the dc solid-state transformer during the fault is proposed, where the ac voltage of transformer is actively limited in the controllable range of both converters in the transformer to effectively suppress the ac component of the fault current. The fault arm current peak and the energy absorbed by the surge arrester in the dc circuit breakers are reduced by 31.8% and 4.9% respectively, thereby lowering the capacities of switching devices and circuit breakers. Alternatively, with the same fault current level, the dc-link node inductance can be halved by using the proposed control, yielding lowered cost and volume. The novel active fault current control mechanism and the necessary control strategy are presented and simulation results confirm its feasibility.

Analysis and Design of a Nonisolated DC Transformer with Fault Current Limiting Capability

A Novel Non-Isolated Boost-Type Alternate Arm DC Transformer With Bidirectional Fault-Blocking Capability

Analysis and Experimental Validation of Current-Fed Switched Capacitor-Based Modular DC Transformer

Design of coaxial transformer for modular isolated DC/DC converters

Over-Current Mechanism and Suppression Strategy of DC Transformer in Multiterminal Interconnected Flexible DC Distribution Network

A Novel High-Voltage DC Transformer Based on Diode-Clamped Modular Multilevel Converters With Voltage Self-Balancing Capability

Modular Multilevel Resonant DC Transformer with Inherent Balancing Capability

Research on the Transformerless Connection Mode for DC Power Distribution System

Modular DC‐DC Auto‐transformer: Topology, Operation, and System Design

DC Fault Analysis of Modular DC/DC Converter Employing a New Submodule with Damping-Resistor

An Ideal DC Transformer for Active DC Distribution Networks Based on Constant-Transformation-Ratio DABC

A DCM-Based Non-Isolated Step-Down DC Transformer

Standalone Clamping Switched Capacitor-Based Modular DC Transformer for MVdc Application

A Novel Medium-Voltage Hybrid-Cascaded DC–DC Converter with DC Fault-Blocking Capability and Reduced Switch Capacity

An Isolated Modular Multi-level DC Transformer with Embedded Multi-port Current Flow Controller for Meshed DC Distribution Grids

Active Control of DC Fault Currents in DC Solid-State Transformers During Ride-Through Operation of Multi-Terminal HVDC Systems

Design and Implementation of a High-Power DC/DC Converter for HVDC Interconnections with Wide DC Voltage Range and Fault-Blocking Capability

Research on a High Frequency Multi-Winding Transformer Isolated Multilevel Converter

An Adaptive Control Method of DC Transformers Imitating AC Transformers for Flexible DC Distribution Application

Reliability-Focused Analysis of the Performance and Characteristics According to the Secondary Circuit Structure of the Transformer in the Isolated DC–DC Full-Bridge Converter

A Sharing-Branch Modular Multilevel DC Transformer with Wide Voltage Range Regulation for DC Distribution Grids