Shear Strengthening of Reinforced Concrete Beams Using Geopolymer-Bonded Small-Diameter FRP Bars

Kai-Di Peng,Jun-Qi Huang,Bo-Tao Huang,Ling-Yu Xu,Jian-Guo Dai
DOI: https://doi.org/10.1016/j.compstruct.2022.116513
IF: 6.3
2022-11-27
Composite Structures
Abstract:In this study, a comprehensive investigation on the shear behavior of RC beams strengthened with small-diameter CFRP bar-reinforced geopolymer matrix (FRGM) system is presented for the first time. A total of twelve RC beams, including two reference beams and ten strengthened beams, were prepared and tested. Five factors were considered, including bonding methods (geopolymer-bonded vs. epoxy-bonded), matrix types (slag-to-fly ash ratios of 9:1 vs. 6:4), alignment directions of small-diameter CFRP bars (90° vs. 45° to the longitudinal direction), configurations of FRGM layers (single-side vs. double-side), and shear span-to-depth ratios of RC beams ( a/d = 2.4 vs. 3.2). The strengthening efficiency of RC beams with the double-side FRGM layer (1.9 times that of the reference beam) was found to be much larger than that of the RC beams with the single-side FRGM layer (1.2 times that of the reference beam). In addition, the geopolymer-bonded layer showed a similar load capacity (approximately 98%) with its epoxy-bonded counterpart. The use of steel fibers in geopolymer matrix further restrained the development of shear cracks and improved the shear capacity. Finally, a theoretical analysis method was proposed for predicting the shear capacity of the FRGM-strengthened RC beams.
mechanics,materials science, composites
What problem does this paper attempt to address?