6:2 Chlorinated Polyfluoroalkyl Ether Sulfonate As Perfluorooctanesulfonate Alternative in the Electroplating Industry and the Receiving Environment

Jinlin Liu,Yuanyuan Cui,Meiling Lu,Jungang Lv,Liang Dong,Jing Guo,Xiulan Zhang,Youbao Sun,Yeru Huang,Lifei Zhang
DOI: https://doi.org/10.1016/j.chemosphere.2022.134719
IF: 8.8
2022-01-01
Chemosphere
Abstract:Electroplating industry is an important application field of per- and polyfluoroalkyl substances (PFASs) as the chromium mist suppressants. 6:2 chlorinated polyfluoroalkyl ether sulfonate (6:2 Cl-PFAES) and perfluorooctanesulfonate (PFOS) have been the two widely used mist suppressants, and after the ban of PFOS, 6:2 Cl-PFAES will become the dominant suppressant. The behavior and mechanisms of 6:2 Cl-PFAES in the electroplating industry and the receiving environment were studied and compared with PFOS. 6:2 Cl-PFAES behaved similarly with PFOS due to their similar chemical structure. However, some difference exists for the relatively stronger hydrophobicity of 6:2 Cl-PFAES. Up to 35.7 mg/L of PFOS and 13.4 mg/L of 6:2 Cl-PFAES were found in the industrial wastewater influents, and were effectively reduced to 0.3-0.8 mg/L by the interaction with chromium hydroxide through hydrophobic interaction and ligand exchange. The stronger hydrophobicity of 6:2 Cl-PFAES than PFOS resulted in its accumulation in the surface of foams and comparable or less removal during the industrial and municipal wastewater treatment. 6:2 Cl-PFAES exhibited higher bioaccumulation potential than PFOS in the surface water. 6:2 Cl-PFAES emitted by both mists and water may pose health risks to humans. More attentions towards 6:2 Cl-PFAES are needed after the replacement of PFOS by it in the electroplating industry as a global contaminant of emerging concerns.
What problem does this paper attempt to address?