Abstract:Protective relays have been designed with different technologies resulting in electromechanical, solid-state, and numerical devices. Speed and reliability are the two most important characteristics of a protective relay. Other capabilities such as monitoring and recording are supposed to be of secondary priority. The new technology using combination of field-programmable analog arrays (FPAAs) and digital technologies seems to be a breakthrough and has the potential to provide better performance than the present-day numerical relays. The use of FPAAs for designing and implementing overcurrent relay is investigated. The modeling and simulation of a protected system using Matlab are described. Hardware implementation using FPAAs is described. The practical test for different types of fault conditions is presented. The practical results show the ability of the new protection to response to the steady-state fault condition fastly and also can obtain different types of Time–Current characteristics with high accuracy. Also two types of characteristics Inverse Definite Minimum Time type IDMT type and very-inverse type are implemented, the protection system is tested in a fault of line-to-line type and the results show the ability to discriminate the fault condition and isolate the faulted section only, the remaining network can operate normally.

ATmega128 and CPLD-based digital relay protection system design and implementation

Software Design and Realization of Digital Relay Based on ARM Microcontroller

Application of ARM Microcontroller in Embedded Integrated Digital Relay

Research on programmable logical relay protection

Design of a Smart Leakage Current Protector IC

Design & Implementation Of An A-Type Residual Current Circuit Breaker Ic

A Novel Multi-Functional Leakage Current Protector IC Design

Design of an Embedded Synthetic Digital Delay Based on AT91M40800

Application of the Design of Soft PLC in Relay Protection Equipments

Reconfigurable hardware platform design for digital protective relay and its application

Design and Implementation of Multifunction Relay Based on Microcontroller

The SOC design and implementation of digital protective relay based on IP cores

A Design to Improve the Reliability of Relay Protection Control Equipment

Microcomputer-based multifunctional inverse time relaying protection

Design Method of General-Purpose Driving Circuit for CCD Based on CPLD

The Implementation Of Digital Protection In Power System Using Fpga

A Fpga-Based Implementation Of Data Acquisition And Processing For Digital Protective Relays

Design and Implementation of Overcurrent Protection Relay

Implementation of Non-Communication Protection of Double Circuit Line Systems Based on Integrated Protection Platform

Application of Complex Programmable Logic Devices in Memory Radiation Effects Test System

Single Event Effect Protection Design of Output Module of Relay Protection Device