Effect of ash on temperature and particulate emission characteristics of diesel particulate filter during active regeneration
Li-shuang Duan,Pi-qiang Tan,Yi-fan Yin,Yun-peng Li,Di-ming Lou,Zhi-yuan Hu
DOI: https://doi.org/10.1016/j.jclepro.2023.138980
IF: 11.1
2023-09-24
Journal of Cleaner Production
Abstract:As one of the most effective devices to reduce particulate emission from diesel engines, the diesel particulate filter (DPF) has been widely used. However, long-term use of the DPF can cause a large amount of ash to deposit in it, which can significantly affect its performance. In this study, a burner was utilized to deposit ash, derived from four different lubricating oil additives (zinc dialkyl dithiophosphate (Zn-based), calcium sulfonate (Ca-based), magnesium sulfonate (Mg-based), and composite), into four DPFs with the same specification. The four ash-loaded DPFs and a fresh ashless DPF were subsequently tested for active regeneration on an engine bench at the same soot load. The temperature and particulate emission characteristics of the DPFs were measured using thermocouples and a particulate analyzer. The peak regeneration temperature of ash-loaded DPFs moved forward when compared to the fresh DPF, and the peak regeneration temperature of Mg-based DPF reached 694 °C and moved forward to the axial position of 71.5 mm. A low temperature zone appeared at the rear end of edge channels, forming a large temperature gradient up to 75.5°C/cm. The emission of nucleation-mode particulates at each DPF outlet increased to different degrees during active regeneration, especially for the Zn-based DPF, whose particulate concentration even approached 10 8 #/cm 3 . The X-ray computed tomography (X-CT) images of ash-loaded DPFs showed that the distribution of ash in each DPF was quite different, and ash plugs or bridges appeared in the middle and front of some channels, forming a strong blocking effect. It is due to the presence of ash that the soot deposition position moved forward and the wall-flow velocity rose, which increased the local soot density, causing the peak regeneration temperature to rise and move forward. The increase in wall-flow velocity reduced the diffusion filtration efficiency of ash-loaded DPFs, so escaped particulates that were broken up from soot agglomerate burning increased.
environmental sciences,green & sustainable science & technology,engineering, environmental