Abstract:Installation of renewable energy to building heating systems with cost-effective and affordable ways is becoming an ever-growing factor. Heat pump (HP) is a high energy efficient renewable energy device which can be a renewable-based alternative to fossil fuel boilers in buildings. Air source heat pumps (ASHPs) as a promising solution achieve the carbon reduction target in the domestic sector, but the limitation of electricity consumption and low supply flow temperatures (for most of the standard ASHPs the supplied heat temperature is around 55 °C) will hinder the implementation of ASHP for domestic applications and replace the existing fossil boiler. With 20% of households using heat pumps, the peak grid demand increases by 7.5 GW (14%) making extra burden to the grid. However, the low temperature water supply by ASHP can benefit to the underfloor heating in the building, which provides the most indoor thermal comfort environment. The building integration of photovoltaics (BIPV) is another type of renewable energy, where the PV elements actually become an integral part of the building, by simultaneously serving as building envelope material and acting as power generator. There is a growing consensus that the generated electricity by photovoltaic should provide electricity at the point of use, therefore the BIPV power can be used to drive ASHP. However, the on-site production of solar electricity is an intermittent source, typically the greatest may not be at or near the time of a building’s peak loads for residential demanding. A thermal store is necessary for storing the heat produced by ASHP during the daytime and discharge the heat for later usage. In addition, the high temperature in BIPV need to be regulated in order to avoid the reduction of the solar power conversion efficiency. Phase change materials (PCMs) absorb a large amount of energy as latent heat at a relative constant phase transition temperature and are thus used for passive heat storage and temperature control. PCMs incorporated into BIPV and underfloor heating system in buildings may be suitable for regulating the PV temperature rising and storing the heat from ASHP for underfloor heating.A two-dimensional temperature-based finite-volume numerical simulation model has been developed and experimentally validated for PCM energy store and temperature regulation. Using electricity generated by BIPV to drive the ASHP and store the thermal energy to thermal mass of PCM in underfloor heating system has been studied considerably in this paper. It has been found that the effect of using cooling coil of ASHP (evaporator) to augment the temperature regulation in BIPV keeps PV electricity efficiency at a high level. This paper summarises the results of a detailed theoretical investigation and analysis of solar energy production and storage control in buildings. An optimised combination of using solar power to drive ASHP and store the heat in PCM for underfloor heating could improve the energy efficiency of PV through temperature regulation and may achieve a cost-effective and affordable heating system the building.

Development of Innovative Technologies for Solar-Assisted Heat Pump for Residential Heat Supply

Enhancing Energy Utilisation in Building with Combining Building Integrated PV and Air Source Heat Pump for Underfloor Heating Using Phase Change Materials

Study on Efficient Heating Method by Solar Coupled Air Source Heat Pump System with Phase Change Heat Storage in Severe Cold Region

Prospective Study of a Novel Heat Pump System with Solar Energy Spectral Beam Splitting

Dynamic Energy Analysis of Different Heat Pump Heating Systems Exploiting Renewable Energy Sources

Simulation and experiment of a photovoltaic—air source heat pump system with thermal energy storage for heating and domestic hot water supply

A systematic review of photovoltaic/thermal applications in heat pumps systems

Performance Analysis of the Developed Air Source Heat Pump System at Low-to-Medium and High Supply Temperatures for Irish Housing Stock Heat Load Applications

Assessment of an Integrated Active Solar and Air-Source Heat Pump Water Heating System Operated Within A Passive House in A Cold Climate Zone

Energy and exergy analysis of a novel dual-source heat pump system with integrated phase change energy storage

Performance analysis of solar assisted heat pump coupled with build-in PCM heat storage based on PV/T panel

Hybrid photovoltaic/thermal and ground source heat pump: Review and perspective

Techno-Economic Assessment of Residential Heat Pump Integrated with Thermal Energy Storage

Application of a Multi-Function Solar-Heat Pump System in Residential Buildings

Experimental investigation and feasibility analysis on a capillary radiant heating system based on solar and air source heat pump dual heat source

Photovoltaic Thermal Heat Pump Assessment for Power and Domestic Hot Water Generation

Experimental Investigation of Air-Source Heat Pump Heating System With a Novel Thermal Storage Refrigerant-Heated Panel

Design of Heat-Pump Systems for Single- and Multi-Family Houses using a Heuristic Scheduling for the Optimization of PV Self-Consumption

Scientific and Technological Progress and Future Perspectives of the Solar Assisted Heat Pump (SAHP) System

Review of the Advances in Solar-Assisted Air Source Heat Pumps for the Domestic Sector

Integrated Heat Pump with Phase Change Materials for Space Heating