Abstract:Installation of renewable energy to building heating systems with cost-effective and affordable ways is becoming an ever-growing factor. Heat pump (HP) is a high energy efficient renewable energy device which can be a renewable-based alternative to fossil fuel boilers in buildings. Air source heat pumps (ASHPs) as a promising solution achieve the carbon reduction target in the domestic sector, but the limitation of electricity consumption and low supply flow temperatures (for most of the standard ASHPs the supplied heat temperature is around 55 °C) will hinder the implementation of ASHP for domestic applications and replace the existing fossil boiler. With 20% of households using heat pumps, the peak grid demand increases by 7.5 GW (14%) making extra burden to the grid. However, the low temperature water supply by ASHP can benefit to the underfloor heating in the building, which provides the most indoor thermal comfort environment. The building integration of photovoltaics (BIPV) is another type of renewable energy, where the PV elements actually become an integral part of the building, by simultaneously serving as building envelope material and acting as power generator. There is a growing consensus that the generated electricity by photovoltaic should provide electricity at the point of use, therefore the BIPV power can be used to drive ASHP. However, the on-site production of solar electricity is an intermittent source, typically the greatest may not be at or near the time of a building’s peak loads for residential demanding. A thermal store is necessary for storing the heat produced by ASHP during the daytime and discharge the heat for later usage. In addition, the high temperature in BIPV need to be regulated in order to avoid the reduction of the solar power conversion efficiency. Phase change materials (PCMs) absorb a large amount of energy as latent heat at a relative constant phase transition temperature and are thus used for passive heat storage and temperature control. PCMs incorporated into BIPV and underfloor heating system in buildings may be suitable for regulating the PV temperature rising and storing the heat from ASHP for underfloor heating.A two-dimensional temperature-based finite-volume numerical simulation model has been developed and experimentally validated for PCM energy store and temperature regulation. Using electricity generated by BIPV to drive the ASHP and store the thermal energy to thermal mass of PCM in underfloor heating system has been studied considerably in this paper. It has been found that the effect of using cooling coil of ASHP (evaporator) to augment the temperature regulation in BIPV keeps PV electricity efficiency at a high level. This paper summarises the results of a detailed theoretical investigation and analysis of solar energy production and storage control in buildings. An optimised combination of using solar power to drive ASHP and store the heat in PCM for underfloor heating could improve the energy efficiency of PV through temperature regulation and may achieve a cost-effective and affordable heating system the building.

Performance analysis of solar assisted heat pump coupled with build-in PCM heat storage based on PV/T panel

Analysis on a Photovoltaic-Integrated Solar-Assisted Heat Pump Water Heater

A hybrid photovoltaic and water/air based thermal(PVT) solar energy collector with integrated PCM for building application

Simulation Study on Thermal Performance of Solar Coupled Air Source Heat Pump System with Phase Change Heat Storage in Cold Regions

Photovoltaic Thermal Heat Pump Assessment for Power and Domestic Hot Water Generation

Experimental Study on the Performance of a Solar Photovoltaic/thermal System Combined with Phase Change Material

Performance Analysis of a Photovoltaic Heat Pump

Performance Analysis of a Photovoltaic Panel Integrated with Phase Change Material

Enhancing Energy Utilisation in Building with Combining Building Integrated PV and Air Source Heat Pump for Underfloor Heating Using Phase Change Materials

Thermal performance and energy flow analysis of a PV/T coupled ground source heat pump system

Performance analysis on the heating performance of CPV/T-air dual source heat pump system with finned microchannels heat exchanger

Experimental thermal and electrical performance analysis of a concentrating photovoltaic/thermal system integrated with phase change material (PV/T-CPCM)

Performances of PV/T solar-assisted heat pump system

Operational and structural parametric analysis of a photovoltaic/thermal system integrated with phase change material

Application of PVT Coupled Solar Heat Pump System in the Renovation of Existing Campus Buildings

Performance Analysis of Solar Thermal Storage Systems with Packed Bed Utilizing Form-Stable Phase Change Materials and Heat Pump Integration

Modeling and Simulation Analysis of Photovoltaic Photothermal Modules in Solar Heat Pump Systems

Performance Modeling and Analysis of a PVT-HP System with the Roll-Bond Plate As the Evaporator During Winter Conditions

Feasibility Analysis of a Direct-drive PV Heat Pump System Based on Phase Change Heat Storage

Dynamic Performance of PV/T Solar-assisted Heat Pump System

Thermal evaluation of photovoltaic panels combined pulsating heat pipe with phase change materials: numerical study and experimental validation