Study on the Microstructure and Mechanical Properties of Non-Equimolar NiCoFeAlTi High Entropy Alloy Doped with Trace Elements
Chunfen Wu,Shuzhi Zhang,Jianchao Han,Changjiang Zhang,Fantao Kong
DOI: https://doi.org/10.3390/met13040646
IF: 2.695
2023-03-25
Metals
Abstract:The method of improving the microstructure and thus the properties of alloys by adjusting their composition has been widely used in the study of high entropy alloys (HEAs). However, most studies have focused on improving the properties of HEAs with face-centered cubic (FCC) or body-centered cubic (BCC) structures by adjusting the contents of elements such as Ni, Al, Ti, Cr, Mn and Mo. The doping of B, Mg and Zr also has a certain effect on the mechanical properties of HEAs. In this paper, the phase structure, microstructure, and mechanical properties of Ni45.5Co22Fe22Al5Ti5 HEA doped with B, Mg, and Zr were investigated. The results demonstrated that the three-phase structures of FCC matrix, L12 precipitate, and BCC phase were present in all the as-cast HEAs of Ni45.5Co22Fe22Al5Ti5×0.5 (X = B, Mg, and Zr). The microstructures of the as-cast alloys showed typical dendritic and inter-dendritic architecture. The maximum hardness was found in the alloy doped with B element, with a value of 433 HV. During the compressive test at room temperature, neither the Mg0.5 HEA nor the Zr0.5 HEA cracked until the load limit, but the B0.5 HEA cracked at a compressive strain of about 12%. B0.5 HEA had the highest compressive yield strength of the three alloys, followed by Zr0.5 HEA, while Mg0.5 HEA had the lowest, with values of 1030 MPa, 754 MPa, and 628 MPa, respectively. The work is expected to provide a boost for the research on the optimization of the properties of new HEAs reinforced by precipitation of L12 phase by providing a simple solution-microalloying method.
materials science, multidisciplinary,metallurgy & metallurgical engineering