Abstract:Physically based constitutive equations incorporating the key microstructural mechanisms e.g. dislocations, grain size, etc, have been used widely to predict the stress-strain behaviour of alloys at plastic and viscoplastic conditions. This enables an accurate prediction of the formed geometry as well as the final underlying microstructures. However, these physically based constitutive equations have not been practically validated due to the lack of systematic experimental data at microscopic scale. This leads to a large number of unknown constants required to be determined through various optimization algorithms. The aim of this paper is to provide direct and systematic experimental data by revealing the dislocation (geometrically necessary one) density and grain size evolution of AA6082, which is a widely used high-strength aluminium alloy for automobile structural panels, as functions of strain, strain rate and temperature, and is the first-time using Electron Back Scattering Diffraction (EBSD) technique to visualize the microstructures during the hot deformation. The evolution of the dislocation accumulation during the hot tensile deformation at 300, 450, 530 degrees C using various strain rates (i.e. 1/s, 0.1/s, 0.01/s) was achieved. EBSD maps were analysed on samples submitted to a true strain level of similar to 0.1 and similar to 0.3 under each condition. These maps cover >3000 grains and enable to capture the statistical nature of the geometrically necessary dislocation densities during hot deformation. Despite the rapidly plateaued flow stress curves at high temperatures, a continuously increased average GND density was observed in AA6082 with the imposed true strain levels under all conditions. Dislocation channel structures were observed in the hot deformed samples. Dynamic recrystallization was also observed, which coupled with the GNDs and affected the hardening behaviour of the flow stress-strain curves. This work is the first study, using EBSD, to visualize the high temperature and high strain rate induced dislocation distributions over a relatively large area, providing valuable data that may be used for subsequently improving and calibrating the physically based material models.

Sub-grain Boundary Mobility of 6XXX Alloys During Annealing

The W alloying effect on thermal stability and hardening of nanostructured Cu-W alloyed thin films

Hot Deformation Behavior and Microstructural Evolution of a New Type of 7xxx Al Alloy

Microstructure evolution, constitutive modeling and forming simulation of AA6063 aluminum alloy in hot deformation

Deformation and Fracture Mechanisms of an Annealing-Tailored "bimodal" Grain-Structured Mg Alloy

Research on Grain Coarsening Mechanism of Forged 6061 Aluminum Alloy

Effect of Annealing Treatment on the Microstructure and Mechanical Properties of Ultrafine-Grained Aluminum

Grain Refinement in Hot Working of 2219 Aluminium Alloy: on the Effect of Deformation Mode and Loading Path

Intergranular Micro-Deformation Behavior of a Medium Strength 7xxx Aluminum Alloy

Evolution of Fine Grained Microstructure and Superplasticity in Warm-Worked 7075 Aluminum Alloy

Microstructure Evolution, Mechanical Properties and Deformation Characteristics of Ultrafine-Grained Annealed Pure Aluminum

Quantitative analysis of influence of α-Al(MnFeCr)Si dispersoids on hot deformation and microstructural evolution of Al-Mg-Si alloys

Effect of Grain Size on Hot Deformation Behavior of a New High Strength Aluminum Alloy

Microstructure, Mechanical Property and Thermo-Stability of Traditionally and Severely Deformed Al–Mg–Sc–Zr Alloy

In-situ EBSD study on the microstructure evolution of an Al-Mg-Si-Fe alloy with different precipitation free zones during tension at cryogenic and ambient temperatures

Subgrain Size Modeling and Substructure Evolution in an AA1050 Aluminum Alloy during High-Temperature Compression

Grain Morphology Related Microstructural Developments in Bulk Deformation of 2219 Aluminum Alloy Sheet at Elevated Temperature

Preferential grain growth and textural evolution of AZ31B Mg alloy during annealing after isothermal compression at 400 °C

Grain Structure and Microtexture Evolution During Superplastic Deformation of 5A90 Al-Li Alloy

Quantifying Geometrically Necessary Dislocation Density During Hot Deformation in AA6082 Al Alloy

Evolution of Grain Structure and Dynamic Precipitation during Hot Deformation in a Medium-Strength Al-Zn-Mg-Er-Zr Aluminum Alloy